sold them

 

my red track r's up a few post are also for sale or trade if anyones interested

 

how much are you looking to get for the track r's?

 

Where would you guys want to meet? Theres a track down the road from where I live.. that would be nice, but I dont expect you guys to all drive 90 minutes to come up here. You're mostly in Lewiston / Auburn right?

 

As far as I know 4 of us are in the Brunswick area.

 

$500 for the track r they got 205/50/15 Toyo Proxes on them

 

hey guys i got a question for ya, my 74 plymouth is gettin shipped up next week and it needs some work, you know of any shops where i can get all new wiring done and and all new interior put in?

 

Swapped sub frames today. Got this pretty clean hatch from dsm_this

Ghetto lift

 

^^ damn that looks sketchy. haha




finally made some progress on the turbo project.

started the install today. got a good amount accomplished in the short time we worked on it.

got the charge piping and intercooler mocked up. heat exchanger mounted and coolant lines run. turbo clocked and bolted up. oil return cut to length. down pipe fitted and tac'd up, ready to be fully welded tomorrow when we get back to work.

pretty good day overall. should have everything finished up tomorrow morning then it's time for a good street tune session.

pictures:

engine bay, doesn't look like much was done since the intercooler and lower pipe were removed.



turbo and manifold in their new home.



downpipe tac'd up ready for welding.



my buddy justin after a good day of work.

 

I went to the track today for my very first time ever.. ran a 9.3 @ 82mph.. spinning literally the entire way down the track across the finish line. I was pretty surprised how difficult it was for me to hook, its nothing like the street. What would a good target time and trap be for my car? 240whp civic 2000lbs street tires

 

It was cold today you might get some more traction when it is hot out.

 

so yeah im down to meet anywhere, ill be moving to Litchfield here in a few weeks so ill be close to lewiston/agusta so if you pick a time place and day ill be there

 

damn yo i ran 9.1 wit a stock b16 in a eg what rpm are you launching at? what were your 60' times? 82 mph you should be running around an 8.7 what tires were you running?

 

my crx is up for sale if anyones interested its got a d16z6 swap just about finished up lost interest in the rex wanna put money into my coupe $600 buys it its got an si tranny rywire 0bd-0 to 0bd-1 harness got ground control coilovers on struts 4-2-1 HP header etc.

 

some pics of the final (for the most part) install.

 

^ Sweet install! How are you going to tune it?


I tried launching my first few runs and ran 10s and 11s.. I would just pound the rev limiter in 1st and 2nd then either bog into 3rd or spin through 3rd depending on how hard I was beating on it. My good runs were no launch just rolling into 1st.. My reaction times were around 1.0, and my 60ft was 2.3-2.6

 

Tires are just some 195/60/15 crappy all seasons.

Nice deal on that CRX too

 

i'm using crome and a lc-1 to tune. i've street tuned my turbo setups in the past, not too difficult.


next time at the track try holding the rpms steady and slip the clutch and throttle together, don't be afraid to ride the clutch a little. if you haven't been, preload to prevent drive train shock.

 

 

i had the same prob. at oxford. spun all the way, take more air out of ur tires

 

anyone have a t3 flanged turbo for sale? mine burns oil like crazy.

 

Long time since I've posted up here, anyways, heres the spec:





FNO1RC's


Stromung exhaust


I haz 6 speeds


Header


These go on this week, with some SS lines

 

Where is said track? I had no idea there was one up here

 

I didn't know there was one either. In for answer.

 

Winterport Dragway about 10 minutes from my house

http://www.winterportdragway.com