Team Kickinit/RWDCRX.com K series race header
#1
Team Kickinit/RWDCRX.com K series race header
Thanks to Casey at Burns stainless for the material and collector w/megaphone
It took me and my buddy about 2.5 days, taking our time to make this header right.
We used stainless 304, 24" primaries, from 1-3/4 to 1-7/8, 12" for each length, 4-1 design maximized for making power at 8k to utilize the stock block and stock head.
My buddy will post the latest pics of the race header. Too bad we couldnt tune at R&D because we found out the rod bearing we replaced on cyl#4 would be ok, but no, the crank or the rod surface must have been fucked up b4 we bought the motor.
Enjoy the pics and we do keep that site maintained often
Mikey
Modified by ArcblursxtypeS at 8:47 AM 6/22/2005
Modified by ArcblursxtypeS at 8:49 AM 6/22/2005
It took me and my buddy about 2.5 days, taking our time to make this header right.
We used stainless 304, 24" primaries, from 1-3/4 to 1-7/8, 12" for each length, 4-1 design maximized for making power at 8k to utilize the stock block and stock head.
My buddy will post the latest pics of the race header. Too bad we couldnt tune at R&D because we found out the rod bearing we replaced on cyl#4 would be ok, but no, the crank or the rod surface must have been fucked up b4 we bought the motor.
Enjoy the pics and we do keep that site maintained often
Mikey
Modified by ArcblursxtypeS at 8:47 AM 6/22/2005
Modified by ArcblursxtypeS at 8:49 AM 6/22/2005
Thread
Thread Starter
Forum
Replies
Last Post
Ekasey
All Motor / Naturally Aspirated
87
04-28-2006 07:46 AM
R-Toyz.com
All Motor / Naturally Aspirated
101
02-03-2005 09:12 PM