I have a CB7 with an H22A1 motor in it. Over last summer, I did the transmission swap from an auto to a manual transmission.

Here are pictures of the project so far:
http://s1187.beta.photobucket.com/us...54643431636556

On the left of the photobucket page, you can see all of the progress of the project organized in dated folders, just click on the "show albums and stories" button.

I am at the point that I need to change the ECU and I'm not sure how to proceed. It seems as if all of my vtec components are wired to the ECU, and if I recall, it's a P13. It also has a small box wired to it and I'm wondering if that is the only box that I need to change out for a manual one, or do I need to change out the bigger box as well? I will go and take pictures of the two different boxes that I'm referring to. TIA for the help.

 

Here are the pictures of the two boxes and also wiring to the VTEC components:

http://s1187.beta.photobucket.com/us...78709708052817

I have 3 VTEC component wires connected to the ECU, the green one going to the solenoid, the red going to ????????, and the black going to a ground? I could use some help in knowing what these wires go to, I'm sure it's wired correctly, but just to know what the red and black wires go to would be nice for my knowledge.