90 Integra GS to recieve a B16
#1
Thread Starter
Join Date: Sep 2002
Location: Island Lake, IL, 60042
Posts: 175
Likes: 0
Received 0 Likes
on
0 Posts
90 Integra GS to recieve a B16
I'm selling my motor out of my car and my buddy wants to put it in his 90 Integra GS automatic. I've never done an auto-manual conversion before so. . . . . . How would this conversion work? Pedal assembley, master cylinder, cable trans vs. hydro? What parts are needed?????
Also, I've got questions about the wiring. I'm selling my complete swap, so my p28 ecu is going in. It's a B16 out of a 2000 Si and I've got an obd2 GSR wiring harness, I used to put it in my car (94 Si). The only wire I had to run to get everything going was the knock sensor wiring.
My question is how does the wiring work for this swap? I know about EG swaps, but not much about what I'm about to try to tackle.
Is there anything else I'm missing (shift linkage, axles, mounts, radiator hoses, etc. etc. etc.) Any and all help will be greatly appreciated . Thanks.
clark
Also, I've got questions about the wiring. I'm selling my complete swap, so my p28 ecu is going in. It's a B16 out of a 2000 Si and I've got an obd2 GSR wiring harness, I used to put it in my car (94 Si). The only wire I had to run to get everything going was the knock sensor wiring.
My question is how does the wiring work for this swap? I know about EG swaps, but not much about what I'm about to try to tackle.
Is there anything else I'm missing (shift linkage, axles, mounts, radiator hoses, etc. etc. etc.) Any and all help will be greatly appreciated . Thanks.
clark
Thread
Thread Starter
Forum
Replies
Last Post
Wasabithegosu
Honda CRX / EF Civic (1988 - 1991)
7
06-10-2005 08:04 AM