wheel well clearence
12-17-2006, 06:28 PM
#1
Junior Member
Thread Starter
Join Date: Jul 2006
Location: canton, oh
Posts: 259
Likes: 0
Received 0 Likes
on
0 Posts
wheel well clearence
The wheel wells on an ej8 have a sort of "pinch weld" on the upper portion of them that have a plastic lining over top of them..after a few times of bottoming out (lowered 3" and no i dont want to raise it up) the pinch weld cuts in to the tire and basically shreds it up...i was thinking about grinding that pinch weld off and then laying a piece of sheet metal in its place and welding that into the wheel well so its flat and will still offer the same support as the "pinch weld" has anybody ever done this or know of anybody who has done this any info about this would greatly be appreciated 
Thread
Thread Starter
Forum
Replies
Last Post
