Thin side molding?
#1
Thin side molding?
Hi All, I'm having the hardest time locating the thin side moldings for my EG6. The problem is, I only need one located on the front quarter panel. The smallest piece.
Does anyone know if an EK4 molding will fit in that position? There are a couple people selling the entire OEM set for EG6 for 300 and 400 USD!!!
Thanks in advance.
Does anyone know if an EK4 molding will fit in that position? There are a couple people selling the entire OEM set for EG6 for 300 and 400 USD!!!
Thanks in advance.
#2
Honda-Tech Member
Re: Thin side molding?
Good luck...those are like unicorns. Most all OEM Honda EG parts at this point are discontinued and what is sold is likely holdovers from stock.
I've half contemplated opening up a company that makes discontinued OEM parts like this...but, the market is so small i'd lose my bum.
eBay is your best bet or a good salvage yard.
I've half contemplated opening up a company that makes discontinued OEM parts like this...but, the market is so small i'd lose my bum.
eBay is your best bet or a good salvage yard.
Thread
Thread Starter
Forum
Replies
Last Post
Declectic
Northern California (Sales)
33
06-10-2009 02:40 PM