droppedeg6hatch

well as the title says i have a Skunk2 axleback for a 1992-2000 civic coupe and i drive a 1993 honda civic HATCHBACK so the exhaust pipe is to long and it hits the underbody of the car and **** so how and where should i cut to shorten it and how much should i shorten it by??? any help is better than where im at now and i have someone who will weld it for free so the amount of welds and time doesnt matter....

droppedeg6hatch

bump

TrunkRattlin

sounds like you can cut it just on any straight part of the exhaust pipe take off an in or two, how long is it?

moomakudafi

i have an axle back on my coupe that was for a hatch and i had to extend it about 5 to 6 inches on the straight behind the can. hope this helps

droppedeg6hatch

bump- good points so far

91civicDXdude

if you have someone to weld it for you, they should have the common sense enough to be able to look at the exhaust and tell where it needs to be shortened

mrbigg9032

U ever hear of using a mearuring tape...

droppedeg6hatch

yea i have and i figured it all out it was because the flange didnt line up and **** not because im a total moron but w/e guys