Rear JDM emblem fitment
#1
Rear JDM emblem fitment
I got a legit JDM emblem set for my 97 EJ8. The back emblem doesnt fit properly due to the fact that its a coupe and the TR is a hatch. So any good tricks to make it fit better? I was thinking of putting 3M emblem adhesive around the edges to hold it, but i dont think thats a great idea, I'm scared that if i hit a bump or anything driving down the road it will fall off. What tricks have you guys used?
#6
I never narc'd on nobody!
iTrader: (1)
Re: Rear JDM emblem fitment
Let me give you a gentle introduction to this tech section. First off, we have two stickies you absolutely need to read. The first is the rule sticky. The second is the FAQ sticky. These are not optional reading around here. Second off, something you should know about us. We don't ghetto rig. We don't do "good enough". Proper threads, and proper questions, are given full attention until the problem is solved. "How can I make the square peg fit in the round hole" threads (like yours right here) will consistently get the same answer: Buy a round peg.
#7
Re: Rear JDM emblem fitment
"How can I make the square peg fit in the round hole" threads (like yours right here) will consistently get the same answer: Buy a round peg.[/QUOTE]
Ummmm where did i say the pegs were the problem? Because theyre not. They're already cut off. Let me re-word my questions for you so you can understand. How can i make it sit flush on the trunk?
Ummmm where did i say the pegs were the problem? Because theyre not. They're already cut off. Let me re-word my questions for you so you can understand. How can i make it sit flush on the trunk?
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
JDMTEG98
Honda / Acura
13
07-08-2002 10:54 AM