Problem seating my axle rollers
#1
Honda-Tech Member
Thread Starter
Join Date: Dec 2004
Location: Brisvegas and the Mile High, Ausmerica
Posts: 1,543
Likes: 0
Received 0 Likes
on
0 Posts
Problem seating my axle rollers
So during my swap I somehow seperated my axles slightly.
The three rollers that sit on a spider are meant to be seated inside the inboard joint.
There is a nice diagram in my manual of all of this but I do not have the picture scanned in, sorry.
Anyway, I do not want to have to remove the boot just to reseat these three rollers, does anyone have any ideas, or has anyone has this problem before?
Need this help urgent, the axles are the last thing before my car can go vroom and I am getting very impatient.
The three rollers that sit on a spider are meant to be seated inside the inboard joint.
There is a nice diagram in my manual of all of this but I do not have the picture scanned in, sorry.
Anyway, I do not want to have to remove the boot just to reseat these three rollers, does anyone have any ideas, or has anyone has this problem before?
Need this help urgent, the axles are the last thing before my car can go vroom and I am getting very impatient.
#2
Honda-Tech Member
Re: Problem seating my axle rollers (MonkeyPuzzle)
when i got my swap 1 of the axels was seperated, is it a b-series axel? i know with d-series they just go back together like nothing, but hte b-series have to be lined up a certain way and i had to buy a new boot and ****, take it all apart and clean it all up with brake cleaner and then install it that way, good as new, but too a while to get it to go back together...
Thread
Thread Starter
Forum
Replies
Last Post
integrawow
Honda CRX / EF Civic (1988 - 1991)
5
04-26-2007 08:41 AM