Knock Sensor 1 Wire Only? - D16Y8 Wiring Harness
#1
Honda-Tech Member
Thread Starter
Join Date: Mar 2007
Location: Small Town, USA
Posts: 135
Likes: 0
Received 0 Likes
on
0 Posts
Knock Sensor 1 Wire Only? - D16Y8 Wiring Harness
Hey,
I was unplugging the knock sensor on my 1998 Civic, and it felt a little bit limp when I removed it. After looking at it there was only one wire coming out of the wiring harness connector. The wire is Red/Blue (I think).
I almost **** a brick because my printout says 2 pin...
But looking at the service manual it only talks about one wire (the Red/Blue.) I didn't have a code for this or anything, but I am removing the harness... and I really hope I didn't yank out a wire.
So my question is: should there only be one wire coming out of the 2 pin connector for the knock sensor on a D16Y8 wiring harness...?
Thanks so much in advance! Hopefully this thread will help someone else out.
I was unplugging the knock sensor on my 1998 Civic, and it felt a little bit limp when I removed it. After looking at it there was only one wire coming out of the wiring harness connector. The wire is Red/Blue (I think).
I almost **** a brick because my printout says 2 pin...
But looking at the service manual it only talks about one wire (the Red/Blue.) I didn't have a code for this or anything, but I am removing the harness... and I really hope I didn't yank out a wire.
So my question is: should there only be one wire coming out of the 2 pin connector for the knock sensor on a D16Y8 wiring harness...?
Thanks so much in advance! Hopefully this thread will help someone else out.
#3
Honda-Tech Member
Thread Starter
Join Date: Mar 2007
Location: Small Town, USA
Posts: 135
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post