inline resister install question
09-17-2004, 10:48 PM
#1
Honda-Tech Member
Thread Starter
Join Date: Mar 2003
Location: 972, tx, usa
Posts: 947
Likes: 0
Received 0 Likes
on
0 Posts
inline resister install and rev's question
instead of puttin the resistors right next to the injectors clips, could i add wires to lengthen the inline resistors and place them at the end of the engine harness connecter on the right and splice it in there >? to clean up the install
i have finished installing them, and on the afc hack with wide/narrow both low and high set at -37, while the car sitting still i would punch it to lik 6k and let it go when the rpms reach 1000 below the car wants to die/stall out the rpms just keep droppping then it gets quite low and raises back up sometimes, this happens during driving to
Modified by ironcheftony at 4:04 AM 9/18/2004
i have finished installing them, and on the afc hack with wide/narrow both low and high set at -37, while the car sitting still i would punch it to lik 6k and let it go when the rpms reach 1000 below the car wants to die/stall out the rpms just keep droppping then it gets quite low and raises back up sometimes, this happens during driving to
Modified by ironcheftony at 4:04 AM 9/18/2004
Thread
Thread Starter
Forum
Replies
Last Post
