CTR pistons and Skunk 2 Stage 2 Help.!
12-05-2003, 10:02 AM
#1
Junior Member
Thread Starter
Join Date: Jul 2003
Location: Walnut, CA
Posts: 367
Likes: 0
Received 0 Likes
on
0 Posts
CTR pistons and Skunk 2 Stage 2 Help.!
Im thinking about pairing up Skunk 2 Stage 2 cams along with CTR pistons but I'm not sure what the clearence would be on a moderately stock B16A2. Any and all opinions are welcome, and Im planning on using 91 octane btw. Would the compression be even high enough to make use of the stage two cams?
12-05-2003, 10:45 AM
#3
Honda-Tech Member
Join Date: Apr 2002
Location: Hayward, CA 94541, USA
Posts: 4,281
Likes: 0
Received 1 Like
on
1 Post
Re: CTR pistons and Skunk 2 Stage 2 Help.! (L33T)
that should be fine...as for comp and pinging issues...make sure it's tuned right. I'd suggest using Hondata S100 or 200 too.
12-05-2003, 10:55 AM
#4
Junior Member
Thread Starter
Join Date: Jul 2003
Location: Walnut, CA
Posts: 367
Likes: 0
Received 0 Likes
on
0 Posts
Re: CTR pistons and Skunk 2 Stage 2 Help.! (EF_LSVtec)
I was thinking of getting the whole thing ported to match and polished along with Hondata, I already have a P28 ecu, and the whole skunk2 valvetrain, Im still thinking if i should go with flat valves to up the compression a bit.
12-05-2003, 11:15 AM
#5
Honda-Tech Member
Join Date: Apr 2002
Location: Hayward, CA 94541, USA
Posts: 4,281
Likes: 0
Received 1 Like
on
1 Post
Re: CTR pistons and Skunk 2 Stage 2 Help.! (L33T)
no problem there either. flat valves do raise the comp a bit but not a whole lot...just don't shave the head for than 20K...
Thread
Thread Starter
Forum
Replies
Last Post
lke2drvgsr
All Motor / Naturally Aspirated
2
02-17-2004 11:17 AM
Civichatch2k
All Motor / Naturally Aspirated
9
12-10-2003 03:21 PM
