Z10 catch can fitting
#1
Junior Member
Thread Starter
Join Date: Jul 2002
Location: EGT City, AZ, USA
Posts: 793
Likes: 0
Received 0 Likes
on
0 Posts
Z10 catch can fitting
Does it go in all the way? I put it in last night and there was about 1/4" left. Tried hammering it in with the rubber mallet but wouldnt budge.
#2
Who is Mr Robot?
iTrader: (2)
Join Date: Jul 2004
Location: ATL - Where the Pimps and Players dwell
Posts: 21,474
Likes: 0
Received 10 Likes
on
10 Posts
Re: Z10 catch can fitting (Boofster)
hmmm. hammering with a rubber mallot wouldnt help something thats threaded. lol. id search, this topic has been covered a few times.
#3
Junior Member
Thread Starter
Join Date: Jul 2002
Location: EGT City, AZ, USA
Posts: 793
Likes: 0
Received 0 Likes
on
0 Posts
Re: Z10 catch can fitting (wantboost)
lol...no it's not threaded. I'm talking about the breather blug for the OEM catch can.
I just talked to Z10 and they said yes, it should go in up to the step.
Just FYI for everyone else, lube the o-rings before inserting
I just talked to Z10 and they said yes, it should go in up to the step.
Just FYI for everyone else, lube the o-rings before inserting
Thread
Thread Starter
Forum
Replies
Last Post