Oil feed source????
07-07-2005, 12:40 PM
#1
Member
Thread Starter
Join Date: Apr 2002
Location: Los Angeles, CA
Posts: 3,223
Likes: 0
Received 0 Likes
on
0 Posts
Oil feed source????
I know the most common source for the oil feed line is from the back of the block, but I've heard from a few people that it's also possible to tap it from the front of the block by the cam seal near the VTEC solonoid? (Only on a B-series motor) Is this a reliable source for the feed? Is there enough pressure to push the oil through? Is it too much pressure?
Thanks in advance.
Thanks in advance.
07-07-2005, 02:03 PM
#3
Member
Join Date: Jun 2001
Location: Dothan, AL
Posts: 2,888
Likes: 0
Received 0 Likes
on
0 Posts
Re: Oil feed source???? (TheIntegraGuy)
like here?
https://honda-tech.com/zerothread?id=639633
IMO Either use a GE/greddy plate or t-off the oil pressure sending unit.
https://honda-tech.com/zerothread?id=639633
IMO Either use a GE/greddy plate or t-off the oil pressure sending unit.
Thread
Thread Starter
Forum
Replies
Last Post
totsie7944
Forced Induction
5
05-01-2008 04:52 AM
ceemarun
Forced Induction
9
08-01-2002 08:55 AM