Bolt holes not lining up on Inlinepro Mani and Tial WG
#1
New User
Thread Starter
Bolt holes not lining up on Inlinepro Mani and Tial WG
I have a T3 SS Inlinepro manifold and 38mm Tial WG and I'm having some difficulties bolting the WG to the manifold. Specifically, the holes on the WG seem to be ever so slightly off from those on the manifold. Enough that I can't get the the 2nd bolt in.
Anybody have any ideas or had this problem before? I have two wg flanges where the holes don't line up w/ the manifold either but line up perfectly on the wg.
Anybody have any ideas or had this problem before? I have two wg flanges where the holes don't line up w/ the manifold either but line up perfectly on the wg.
Thread
Thread Starter
Forum
Replies
Last Post
digitalVinyl
Acura Integra
1
03-08-2007 01:54 PM