Block pins?
07-04-2004, 09:17 AM
#1
Honda-Tech Member
Thread Starter
Join Date: Feb 2002
Location: Ride Naked
Posts: 2,929
Likes: 0
Received 0 Likes
on
0 Posts
Block pins?
I've been thinking of doing ths, but I have a ccouple questions.
First, the style I usually see is threaded plugs that go into the block, but I once saw a B18 (member of this boards engine) that had long aluminum rods (~1/2" diameter) placed vertically between the block and sleeve in machined grooves, about every 1 inch or so. Is this a common practice, any more info on it?
Second, where would I purchace either type of pins?
Finally, is either of these still recomended?
First, the style I usually see is threaded plugs that go into the block, but I once saw a B18 (member of this boards engine) that had long aluminum rods (~1/2" diameter) placed vertically between the block and sleeve in machined grooves, about every 1 inch or so. Is this a common practice, any more info on it?
Second, where would I purchace either type of pins?
Finally, is either of these still recomended?
07-06-2004, 07:02 AM
#4
Member
Join Date: Aug 2001
Location: Baltimore, maryland, usa
Posts: 5,084
Likes: 0
Received 0 Likes
on
0 Posts
Re: Block pins? (krustindumm)
You can get the pins from endyn(www.theoldone.com).. Look on homemadeturbo.com under tech projects->block pinning and youll see how its done.. Im going to do this to my block after this race season..
Thread
Thread Starter
Forum
Replies
Last Post
