is .5 mm over bore safe on stock ls
#1
Junior Member
Thread Starter
Join Date: Apr 2008
Location: worcester, mass, usa
Posts: 27
Likes: 0
Received 0 Likes
on
0 Posts
is .5 mm over bore safe on stock ls
hello i am new here i am a experienced honda technitian and i am building a 92 integra ls turbo my setup is stock block and head (milled both) and i want to put wiseco pistons eagle rods and performance rings all new gasket and seals and im going to run a 57 trim turbo setup on it if i go overbore +.5 mm on stock sleeves will my engine hold up i have never tried this before and any advice is appreciated thanks
Thread
Thread Starter
Forum
Replies
Last Post