Hey guys. Im stressing out pretty hard because I am having issues datalogging in my turbo integra. As of yesterday I was datalogging fine. Today i went out to get some more data and was rushing and jumped in, turned on freelog and fired it up. It started but immediately after starting it, i realized i didnt put the chip in. Shut it right back off, put the chip in and it fired right back up. Since then though, it will allow me to connect but the battery reads 22222e+25, igniton reads 6, eld 81 and nothing else. I burned a couple new chips with crome(made sure checksum and quicklog+rtp was enabled) and same. I tried a different chipped ecu and the same. I also changed the scalers in freelog earlier, so after the ecu and chip change out, i tried resetting that back to normal. I dont even know what else to try. I disconnected the battery for like 5 minutes and ecu for the same and still nothing. Im going to try uninstalling and reinstalling freelog, but i doubt its gonna help. Anyone know what else to check/test? Any help would be greatly appreciated. I already know im a huge dummy so I'm not looking for people to tell me.

 

I downloaded the drivers and software to my wife's laptop and it works once again. It must have somehow corrupted thw driver or software since it was plugged in when I started it. Sorry for the wasted post, it can certainly be deleted.