Question about electrolysis!
#1
Honda-Tech Member
Thread Starter
Join Date: Sep 2011
Posts: 118
Likes: 0
Received 0 Likes
on
0 Posts
Question about electrolysis!
Ok, so I recently asked a question in this section about what the best way to clean the passages of a freshly resurfaced bottom end would be. I was originally going to take the factory plugs out and blast inside with a pressure washer. I still might do this for some reassurance, but I was wondering if electrolysis could help me out in any way.
I was wondering if during the electrolysis process, the aluminum shavings that may have got inside the passages, would get pulled out and stick to the metal on the outside of the container that I would conduct this process in.
Thanks in advance!
- DJ
I was wondering if during the electrolysis process, the aluminum shavings that may have got inside the passages, would get pulled out and stick to the metal on the outside of the container that I would conduct this process in.
Thanks in advance!
- DJ
Thread
Thread Starter
Forum
Replies
Last Post