S2K CMC Test FIt - Pressed Studs or Threaded??
#1
Honda-Tech Member
Thread Starter
S2K CMC Test FIt - Pressed Studs or Threaded??
Anyone know if these pins/studs are pressed in or threaded in??
Barely get the nuts threaded due to the adapter plate.
Barely get the nuts threaded due to the adapter plate.
#2
Honda-Tech Member
Re: S2K CMC Test FIt - Pressed Studs or Threaded??
Most likely pressed.
What kit or where did you buy it from?
What kit or where did you buy it from?
#3
Honda-Tech Member
Thread Starter
Re: S2K CMC Test FIt - Pressed Studs or Threaded??
Bought it from MAKOTO CORP, an amazon seller; but it has Nissin stamped on the side and is an Adler S2000 CMC so should be same as anything dealer would provide. The adapter i ordered from StreetRays.
Think Im going to take it out make sure its not somehow catching threads on the firewall and then maybe put in integra CMC with adapter and how many threads are through firewall then.
If that doesn't work i might take S2000 CMC to dealer and compare thread stud length to their CMC.
Think Im going to take it out make sure its not somehow catching threads on the firewall and then maybe put in integra CMC with adapter and how many threads are through firewall then.
If that doesn't work i might take S2000 CMC to dealer and compare thread stud length to their CMC.
Last edited by TurboTeg332; 02-10-2023 at 09:19 AM.
#4
Honda-Tech Member
Thread Starter
Re: S2K CMC Test FIt - Pressed Studs or Threaded??
After further investigation noticed under the pedal plate thing whatever it is there appears to be a spacer under neath (rubber foam mat) on the inside of the firewall too.
Does anyone else have a spacer like this on the inside of firewall ??
Does anyone else have a spacer like this on the inside of firewall ??
#5
Honda-Tech Member
Re: S2K CMC Test FIt - Pressed Studs or Threaded??
Thats weird...
What chassis? DC2?
Can you try removing it?
Maybe if you can swap the studs it might fit better.
What chassis? DC2?
Can you try removing it?
Maybe if you can swap the studs it might fit better.
#7
Honda-Tech Member
Thread Starter
Re: S2K CMC Test FIt - Pressed Studs or Threaded??
Thats what i wanted to do but not sure where get press in studs like what came out of CMC. THey look like what goes on wheel lug studs but an M8 size.
I got two bolts that were longer in after pressed the press pins out and it fits now but would been nice to have longer press pins but oh well.
Thread
Thread Starter
Forum
Replies
Last Post