B20 VTEC
Thread Starter
Joined: Jan 2004
Posts: 42
Likes: 0
From: Tallahassee, FL, U.S
B20 VTEC
sup ya'll what do ya'll think about a b20 block 20 over, with eagle rods, JE pistons and rings (~12:1) with new crank bearings, top side crowder stage 3 cams .... trying to decide what valve train to go with.. not sure leaning towards skunk2.... ideas? oh and act extreme pressure plate street disc and light wieght fly wheel, enjo motor mounts...
I'm a Jackass
Joined: Jun 2003
Posts: 925
Likes: 0
From: stillwater, ok, us
Re: B20 VTEC (GsRwHiTe)
I think this is a silly post. what are you asking? my opinions on your pretend setup? purchase the parts, put them together, then YOU tell US the results bro. good luck
Member
Joined: Jun 2004
Posts: 3,253
Likes: 0
From: VTECH/BLACKSBURG/NOVA
Re: B20 VTEC (Muckman)
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by GsRwHiTe »</TD></TR><TR><TD CLASS="quote">sup ya'll what do ya'll think about a blah blah blah blah blah blah blah blah blah blah blah blah blah...</TD></TR></TABLE>
Thread Starter
Joined: Jan 2004
Posts: 42
Likes: 0
From: Tallahassee, FL, U.S
Re: B20 VTEC (Slimm-rw)
say brah.. i'm asking before i buy because the motor is chilling at my boys shop and i'm ready to dump about 3 G's on just parts. Plus maybe someone has already done it and found flaws and would like to share them. geezz my bad i thought that was one of the reasons for this forum. what was i thinking......
Thread
Thread Starter
Forum
Replies
Last Post