siblues

iTrader: (1)

I am looking for either a 2.5 to 2.75 or 3.0 to 2.75 v-band adapter?I have looked around with no luck.I am under the impression this would be simple to do the smaller of the two flanges would just have to be made a bit taller to seal inside the clamp with the larger flange right?I have never used v-bands and I am just trying to figure out the easiest way to get a 70mm TB to a 2.5 inlet precision intercooler.Any help would be greatly appreciated.Thanks

that-guy

interesting concept, but not worth the headache. just use the same size v-band on each end, but use a conical reducer on the tube to attach to the v-band. they are super common and can be found at really any metal supplier

siblues

iTrader: (1)

Yeah I was looking into those also.Thanks and maybe someone knows where to get one or they may even make them.

siblues

iTrader: (1)

Any ideas guys or can anyone make them?Thanks

that-guy

Ace Stainless and Verocious Motorsports sells the reducers

project504

Forced Performance Turbochargers: FP 2.5" - 3" V-band Clamp & Transition Flange Set

this should work goes from 3" down to 2.5 inch, you could just cut it were it comes to 2.75"

project504

never mind that is stainless steel .