We Need this to be sticky'd
#1
Honda-Tech Member
Thread Starter
iTrader: (2)
Join Date: Jun 2007
Location: pocatello, idaho, u.s.a.
Posts: 3,648
Likes: 0
Received 0 Likes
on
0 Posts
We Need this to be sticky'd
What are the torque spec for the pressure plate bolts to the flywheel? i need this info from ya'll as I have tried my Haynes manual but all it says anything about are the drive-plate bolts. Help please.
#2
Honda-Tech Member
Re: We Need this to be sticky'd
its 19 ft lbs for d-series but you didn't tell us what car you have, i would only assume it is the same for b series since they use the same bolts.
#4
Honda-Tech Member
Join Date: Nov 2004
Location: 40.201N, 77.189W, PA
Posts: 4,738
Likes: 0
Received 7 Likes
on
4 Posts
Re: We Need this to be sticky'd
No need for them to be that tight though. As long as everything is even, they won't back out.
BTW, the Hayne's will have the pressure plate bolt torque specs. Look harder.
BTW, the Hayne's will have the pressure plate bolt torque specs. Look harder.
#5
Honda-Tech Member
Thread Starter
iTrader: (2)
Join Date: Jun 2007
Location: pocatello, idaho, u.s.a.
Posts: 3,648
Likes: 0
Received 0 Likes
on
0 Posts
Re: We Need this to be sticky'd
I looked. It said it was on 2B-16, that said to refer to 2A-14. Specs are in the front of each chapter and the specs for both are the same. 54lbs.
Thread
Thread Starter
Forum
Replies
Last Post