We Need this to be sticky'd
Thread Starter
Honda-Tech Member
iTrader: (2)
Joined: Jun 2007
Posts: 3,648
Likes: 0
From: pocatello, idaho, u.s.a.
We Need this to be sticky'd
What are the torque spec for the pressure plate bolts to the flywheel? i need this info from ya'll as I have tried my Haynes manual but all it says anything about are the drive-plate bolts. Help please.
Honda-Tech Member
Joined: Nov 2004
Posts: 4,738
Likes: 8
From: 40.201N, 77.189W, PA
Re: We Need this to be sticky'd
No need for them to be that tight though. As long as everything is even, they won't back out.
BTW, the Hayne's will have the pressure plate bolt torque specs. Look harder.
BTW, the Hayne's will have the pressure plate bolt torque specs. Look harder.
Thread Starter
Honda-Tech Member
iTrader: (2)
Joined: Jun 2007
Posts: 3,648
Likes: 0
From: pocatello, idaho, u.s.a.
Re: We Need this to be sticky'd
I looked. It said it was on 2B-16, that said to refer to 2A-14. Specs are in the front of each chapter and the specs for both are the same. 54lbs.
Thread
Thread Starter
Forum
Replies
Last Post