Valve adjustment on 97 gsr motor now shaking
#1
Honda-Tech Member
Thread Starter
Join Date: Apr 2004
Location: bay area, ca
Posts: 2,843
Likes: 0
Received 0 Likes
on
0 Posts
Valve adjustment on 97 gsr motor now shaking
had a friend do a valve adjustment on my 97 gsr motor, afterwards the ticking was still there and the engine was shaking/vibrating a little. so i had another more knowledgeable friend redo the valve adjustment, he said the 1st guy didnt do it correctly, and adjusted it to factory specs, he also adjusted my timing to factory because for some reason it was retarded 6 degrees. my engine feels the same maybe slightly smoother now not sure, but the engine still shakes a little at idle, not as bad as after the first adjustment, but before it didnt shake at all. what could it be? i think i read somewhere before that it could be a bent valve spring? thanks
#3
Honda-Tech Member
Thread Starter
Join Date: Apr 2004
Location: bay area, ca
Posts: 2,843
Likes: 0
Received 0 Likes
on
0 Posts
Re: Valve adjustment on 97 gsr motor now shaking (simpleaznx)
anybody? feels like my car is idling low/almost dying, and i may hear slight backfire time to time.
#4
Honda-Tech Member
Join Date: Sep 2003
Location: Hanover, MD, USA
Posts: 515
Likes: 0
Received 0 Likes
on
0 Posts
Re: Valve adjustment on 97 gsr motor now shaking (simpleaznx)
Are you sure they used the correct clearances?? Is the mechanical timing correct? There could be alot of things that are causing the problem.
Sal
Sal
#5
Honda-Tech Member
Join Date: Feb 2003
Location: LA, CA
Posts: 79
Likes: 0
Received 0 Likes
on
0 Posts
Re: Valve adjustment on 97 gsr motor now shaking (simpleaznx)
Sounds similar to the problem I had. If you can, try a compression test, and see if you're compression is good. Could be a bent valve, worse case, bad piston rings.
#6
Honda-Tech Member
Thread Starter
Join Date: Apr 2004
Location: bay area, ca
Posts: 2,843
Likes: 0
Received 0 Likes
on
0 Posts
Re: Valve adjustment on 97 gsr motor now shaking (TurboLSVtecTeg)
pretty sure second guy used correct clearances, he used the one under the hood, i think its like .6 .7 somewhere around there. yeah ill try to compression test it asap, i was also thinking bent valve because i read somewhere that thats a possibility in a bad valve adjustment
Thread
Thread Starter
Forum
Replies
Last Post