Machine shop in Seattle area? Need to resurface flywheel...
#1
Honda-Tech Member
Thread Starter
Join Date: Jul 2002
Location: Seattle, WA
Posts: 2,505
Likes: 0
Received 0 Likes
on
0 Posts
Machine shop in Seattle area? Need to resurface flywheel...
Im in desperate need of a machine shop. I need to get my H22 flywheel resurfaced by friday so I can get some tune time in and get ready for Battle of the Imports!! Does anyone know of any in the Seattle/Auburn area? TIA!
-Osman
-Osman
#5
Honda-Tech Member
Join Date: May 2004
Location: Wrenching and Drinkin', Montana
Posts: 4,346
Likes: 0
Received 0 Likes
on
0 Posts
Re: (hadboosttroy)
my budy all the way up in arlington could do it, he runs the machine shop at NAPA there.... did my old stock flywheel, my bros d-series, and a few other friends, then again battle of the imports is tomorrow, so good luck....
#6
Honda-Tech Member
Thread Starter
Join Date: Jul 2002
Location: Seattle, WA
Posts: 2,505
Likes: 0
Received 0 Likes
on
0 Posts
Re: (ProjectLSVTEG)
Thanks for all the replies. I found out the the Big Wheel auto parts here in Kent does the stepped flywheels so I'm good now. Thanks agian.
Good luck to everyone at BATTLE tomorrow!
-Osman
Good luck to everyone at BATTLE tomorrow!
-Osman
Thread
Thread Starter
Forum
Replies
Last Post
nb0
Tech / Misc
3
09-06-2009 01:48 AM
Calvinator
Honda Civic / Del Sol (1992 - 2000)
2
10-07-2004 10:48 AM
area, cost, flywheel, good, honda, machine, machining, public, resuface, resurface, resurfaced, resurfacing, seattle, shop, washington