Found bad connecting rod bearing, now what?
#1
Thread Starter
Join Date: May 2002
Location: Off Course
Posts: 1,159
Likes: 0
Received 0 Likes
on
0 Posts
Found bad connecting rod bearing, now what?
Discovered a bad connecting rod bearing in a Yamaha R6 engine. My question is, how do I know if the crank journal needs to be reground? Visually it looks okay but I am not an expert. This engine revs past 15,000 rpm so I don't think "looks okay" cuts it Do I just need to buy a new bearing and plastigage it? If you're curious, here's the bad bearing...
http://www.we-todd-did-racing.com/we...MxeTU0MQ%3D%3D
http://www.we-todd-did-racing.com/we...MxeTU0MQ%3D%3D
#2
Re: Found bad connecting rod bearing, now what? (Angry Joe)
Check the factory tolerances and mike the thing , this is the only way to tell if it is within the range . make shure you mike it in more than one location on the jornal this will insure it is round. I mean the more places you check it the better (all the way around)
Thread
Thread Starter
Forum
Replies
Last Post
dbb95ex
Honda Civic / Del Sol (1992 - 2000)
8
08-12-2009 09:07 AM
rextasy
Honda CRX / EF Civic (1988 - 1991)
3
05-14-2007 10:19 AM