DIY skunk2 pro or blackworks upper ball joint for crx camber kit mod
#1
Honda-Tech Member
Thread Starter
Join Date: Dec 2008
Location: Stinky Baltimore
Posts: 93
Likes: 0
Received 0 Likes
on
0 Posts
DIY skunk2 pro or blackworks upper ball joint for crx camber kit mod
well everyone knows that the skunk2 ball joints on there camber kits die in a short amount of time and i figured i post a diy for making them work since there little different then what skunk2 provides and this mod works for ither the newer pro series ball joints or the blackworks racing ones.
tool list
10mm wrench and socket
14mm wrench
17mm wrench
a BMF hammer
a cutoff wheel
a jack
ok lets get started here is what the brand new ball joint looks like un touched.
you take your cut off wheel and grind the ends off a little bit so it looks like this
then install so they fit like this
then all finished this is the second set ive done and havent had a problem i may install grese fittings in it so they last forever well in a perfect universe
tool list
10mm wrench and socket
14mm wrench
17mm wrench
a BMF hammer
a cutoff wheel
a jack
ok lets get started here is what the brand new ball joint looks like un touched.
you take your cut off wheel and grind the ends off a little bit so it looks like this
then install so they fit like this
then all finished this is the second set ive done and havent had a problem i may install grese fittings in it so they last forever well in a perfect universe
#2
Honda-Tech Member
Join Date: Jun 2010
Location: Oregon
Posts: 770
Likes: 0
Received 0 Likes
on
0 Posts
#6
Honda-Tech Member
Thread Starter
Join Date: Dec 2008
Location: Stinky Baltimore
Posts: 93
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
dc2ls-vtec
Suspension & Brakes
7
10-20-2009 02:32 PM