Why shouldn't I?
#1
Why shouldn't I?
Disassemble my distributor assembly? CYP CKF TDC sensors. I saw this picture but no reason as to why not. http://www.justanswer.com/honda/4h70x-95-accord-2-2-replace-distributor-check-fix.html
#2
Honda-Tech Member
Re: Why shouldn't I?
Sure you can. But I think what they are trying to say if there is a problem replace the entire unit. They don't individually sell the sensors. If you can fiddle around or take one from a spare distributor go for it.
For most dealerships and repair shops the best way of avoiding tow trucks or warranty concerns is replace the units as a whole. For the technically savy DIY kind of person, anything goes.
For most dealerships and repair shops the best way of avoiding tow trucks or warranty concerns is replace the units as a whole. For the technically savy DIY kind of person, anything goes.
#4
Re: Why shouldn't I?
That's what I thought but I took mine out and now when I re assemble it the lowest sensor an the magnetic pickup on the drive shaft are interfering. When I put the shaft in and try to rotate it they hit and I can force it past it but it doesn't spin freely. Any ideas why?
#5
Honda-Tech Member
Join Date: May 2008
Location: danielson, ct, 06239
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
Re: Why shouldn't I?
if i remember correctly the lower sensors have a little slot where the screw down loosen it a little then put shaft in then tighten the screws id imagine theres a tolerance between the 2 prolly need a feeler gauge
#7
Re: Why shouldn't I?
So I got home and took it all apart again and it turns out one of the hold down screws for another sensor got stuck to the bottom of the magnet and I didnt see it when I put it together. Took the screw off and tried again. Works perfectly. Thanks for all the help. I was worried I fucked up my dizzy for a bit there haha
Thread
Thread Starter
Forum
Replies
Last Post