Honda-Tech - Honda Forum Discussion

Notices
 
Page 1 of 7
1
2
3
Last »
Search: Posts Made By: freydaddy
Showing results 1 to 25 of 166
Search took 0.30 seconds.
Forum: Forced Induction
11-09-2014, 06:02 PM
Replies: 59
Views: 11,585
Posted By freydaddy

Re: oil temp too hot?

I checked on the SPAL
Nice stuff. EXPENSIVE...$200
If I was absolutely sure that was my problem, I would not hesitate to get it.
Forum: Forced Induction
11-09-2014, 05:59 PM
Replies: 59
Views: 11,585
Posted By freydaddy

Re: oil temp too hot?

back of the block
afr reads 20+ "blinking"...Glowshift WB may be shit, the car runs great so I think the brain box is bad.
wrapped the downpipe by the pan
when I figure the best method, I am...
Forum: Forced Induction
11-01-2014, 10:33 AM
Replies: 59
Views: 11,585
Posted By freydaddy

Re: oil temp too hot?

put some miles on the civic today. pushed boost a lot. with the outside temp not exceeding 50, I never saw over 220 degrees oil temp and water never got too hot. leads me to think my only problem is...
Forum: Forced Induction
10-27-2014, 07:28 PM
Replies: 59
Views: 11,585
Posted By freydaddy

Re: oil temp too hot?

http://s15.postimg.org/kcna6zzaf/IMG_20120726_185034.jpg (http://postimg.org/image/kcna6zzaf/)
this is an OLD pic of my setup
Forum: Forced Induction
10-27-2014, 07:16 PM
Replies: 59
Views: 11,585
Posted By freydaddy

Re: oil temp too hot?

I will take your advice and run water coolant lines to the CHRA.
Any advice on the best routing in a 91 civic?
Do I tap into the heater hoses, rad. hoses?
What types of fittings?

I will also...
Forum: Forced Induction
10-02-2014, 02:41 PM
Replies: 59
Views: 11,585
Posted By freydaddy

Re: oil temp too hot?

oil temp got to 260 on the way home from work
I was going about 90 mph for a few minutes (3)
when I shut it down and pop the hood, there is a noticeable amount of smoke coming from the turbo.
I...
Forum: Forced Induction
09-10-2014, 05:07 PM
Replies: 59
Views: 11,585
Posted By freydaddy

Re: oil temp too hot?

Getting a retune tomorrow. Msd installed. New Alpha half radiator installed. Water temp still getting hot with a 5 mile trip, oil temp was 230.
I used a laser thermometer and noticed #2 & #3...
Forum: Forced Induction
08-23-2014, 02:36 PM
Replies: 59
Views: 11,585
Posted By freydaddy

Re: oil temp too hot?

My a/f is 14.7 at idle up to 2500 rpms. 13.2ish going down the interstate. No more than 15.6. The downpipe and ex manifold are both wrapped. I don't have the typical low comp pistons that most people...
Forum: Forced Induction
08-21-2014, 05:31 PM
Replies: 59
Views: 11,585
Posted By freydaddy

Re: oil temp too hot?

My commute to work is 20 minutes mostly interstate at 70 to 80 mph(3000 rpms). After ten minutes or fifteen it gets to 250 and stays. Daily driver rarely sees wot and 8 pounds of boost. T3/T4, big...
Forum: Forced Induction
08-21-2014, 02:05 PM
Replies: 59
Views: 11,585
Posted By freydaddy

Re: oil temp too hot?

SMH. Just realized my turbo drain line to the oil pan is 10an size which is 3/8". I was told it needs to be 12an which is 1/2". Maybe the problem the whole time. It's not letting the oil out of the...
Forum: Forced Induction
08-21-2014, 12:56 PM
Replies: 59
Views: 11,585
Posted By freydaddy

Re: oil temp too hot?

Well, oil temp got to 250 this afternoon which in turn makes the water temp get too high and the check engine light comes on. Will adding an oil cooler help the water temp stay down since the air...
Forum: Forced Induction
08-21-2014, 08:25 AM
Replies: 59
Views: 11,585
Posted By freydaddy

Re: oil temp too hot?

Update
This morning,I drove to work with the fan on the whole time. The temp never got over 220. Makes me think the intercooler is blocking most of the air.
Forum: Forced Induction
08-20-2014, 12:57 PM
Replies: 59
Views: 11,585
Posted By freydaddy

Re: oil temp too hot?

Is that typical? I knew that was an option. But I am limited on space. 91 hatch. The intercooler is blocking a lot of air, too. Also, the turbo has the water ports that I am not using.
Forum: Forced Induction
08-20-2014, 08:37 AM
Replies: 59
Views: 11,585
Posted By freydaddy

oil temp too hot?

D series built block and head. T3/T4 turbo, 750cc ID, factory dizzy. Oil temp gets to 250°F. I am a little worried. New oil 5w 30 Amsoil. When I shut the engine off, I see a bit of smoke coming from...
Forum: Engine Management and Tuning
01-19-2014, 05:27 PM
Replies: 7
Views: 2,973
Posted By freydaddy

hondata s300 running rich

Lambda is @ 12.4:1
550cc injectors are @ 2.22 ms
How can I lean it out? Tables?
(I had a semi-base tune interrupted due to failing starter.)
Forum: Forced Induction
06-09-2012, 04:49 PM
Replies: 3
Views: 964
Posted By freydaddy

inlet elbow for wastegate?

just wondering if a 90 elbow is produced for the inlet side of the wastegate?
I see plenty of 45's, but i need a 90 so i can shut my hood:thud:
I have an ED hatch with the D16.
I almost think I...
Forum: Honda CRX / EF Civic (1988 - 1991)
03-15-2012, 04:16 PM
Replies: 20
Views: 2,422
Posted By freydaddy

Re: D16ZC Wont pass emissions.

retard the piss out of your timing until you pass.:thumbup:
Forum: Performance
03-02-2012, 10:09 AM
Replies: 132
Views: 27,641
Posted By freydaddy

Re: ****GEARSPEED K/B/H/D-Series Transmission Rebuild Kits***H-T Discounts!!!****

request for quote on transmission rebuild kit for D series cable Si 1991
Forum: Performance
03-02-2012, 10:00 AM
Replies: 2,203
Views: 162,343
Posted By freydaddy

Re: SUPERTECH RACE SPRINGS / RETAINERS / VALVES | FREE OVERNIGHT SHIPPING

request for quote on valvetrain package for d16z6 build
s.s. valves, springs, retainers, guides
Forum: Honda CRX / EF Civic (1988 - 1991)
03-02-2012, 09:33 AM
Replies: 16
Views: 52,903
Posted By freydaddy

Re: D Series LSD Transmissions

doing a lot of research, i have decided to go the route of getting the Mfactory LSD and finding someone professionally in the area to rebuild the other si tranny in the shed (grinds 1st and 2nd and...
Forum: Tech / Misc
03-02-2012, 09:24 AM
Replies: 29
Views: 10,636
Posted By freydaddy

Re: fuel injector swap issue

i replaced the main relay, and now it runs fine.
seems that i fried part of it when i went to probing injector wires.:mad:
just updating this thread, cuz i forgot.
Forum: Honda CRX / EF Civic (1988 - 1991)
02-29-2012, 05:21 PM
Replies: 16
Views: 52,903
Posted By freydaddy

Re: D Series LSD Transmissions

what you got Tyson? How much shipped from cali to 37075?
Forum: Honda CRX / EF Civic (1988 - 1991)
02-29-2012, 12:13 PM
Replies: 16
Views: 52,903
Posted By freydaddy

Re: D Series LSD Transmissions

is there any difference between the DOHC ZC and the SOHC ZC tranny?
gearing, final drive?
Forum: Honda CRX / EF Civic (1988 - 1991)
02-28-2012, 06:33 PM
Replies: 16
Views: 52,903
Posted By freydaddy

Icon2 D Series LSD Transmissions

it seems pretty easy to find a LSD tranny in the B series.

trying to find out ALL the options we have to get real traction with the D.

as far as i know, JDM ZC or JDM D15B VTEC was the only 2...
Forum: Honda Civic / Del Sol (1992 - 2000)
02-08-2012, 01:36 PM
Replies: 6
Views: 3,326
Posted By freydaddy

Re: map sensor issue

car is running fantastic. and no trouble codes:wave:
still puzzled about the negative reading from the map sensor though.
at WOT, it almost zeros out.
Showing results 1 to 25 of 166
 
Page 1 of 7
1
2
3
Last »


 
Forum Jump


All times are GMT -8. The time now is 07:53 PM.