Honda-Tech - Honda Forum Discussion

Notices
 
Page 1 of 2
1
2
Search: Posts Made By: silverAC
Showing results 1 to 25 of 39
Search took 0.49 seconds.
Forum: Acura Integra
04-14-2008, 06:02 PM
Replies: 5
Views: 420
Posted By silverAC

Re: (silverAC)

wht/blu=switched power
Forum: Acura Integra
04-14-2008, 06:01 PM
Replies: 5
Views: 420
Posted By silverAC

Re: (suno)

black=ground
red/blk=illumination
red=dimmer
Forum: Acura Integra
04-13-2008, 06:50 PM
Replies: 5
Views: 420
Posted By silverAC

Re: Identify these wires. (silverAC)

sorry, lighters in hondas are switched so the white/blue would be switched if it leads to the lighter socket.
Forum: Acura Integra
04-13-2008, 06:48 PM
Replies: 5
Views: 420
Posted By silverAC

Re: Identify these wires. (suno)

i wouldn't assume that black is ground but i can see from the pic that it is. follow the wires. where do they go? Typically a honda uses red/black as illumination voltage and white/blue is...
Forum: Acura Integra
04-13-2008, 06:42 PM
Replies: 2
ICU
Views: 1,090
Posted By silverAC

Re: ICU (ivan93egreppin210)

icu is an integrated control unit. there are lots of icu's in a car but not one that controls all of those things in an integra. has it been raining like crazy? there may be water in the underhood...
Forum: Acura Integra
04-13-2008, 06:36 PM
Replies: 6
Views: 4,980
Posted By silverAC

Re: Driver's Low Beam Not Working, Help! (A's 94 GSR)

use a meter to check for voltage. use the power and ground wire from the connector that plugs into the light. if you've swapped bulbs and the problem remained than you should have little to no...
Forum: Acura Integra
04-08-2008, 10:08 AM
Replies: 2
Views: 335
Posted By silverAC

the wiring coming in to the door is on a plug. ...

the wiring coming in to the door is on a plug. basically the entire door is plugged in to the car. check the harness between the door and the car(on the car side), if this came unplugged it could...
Forum: Acura Integra
04-06-2008, 06:05 PM
Replies: 10
Views: 764
Posted By silverAC

i had a similar problem. i was only abe to shift...

i had a similar problem. i was only abe to shift when engine speed and vehicle speed matched for the gear i wanted. shifted ok when i granny shifted, if i wound out a gear i couldn't get the next...
Forum: Acura Integra
04-02-2008, 09:05 PM
Replies: 9
Views: 5,111
Posted By silverAC

i have a 96 ls, my pcv valve is on the valve...

i have a 96 ls, my pcv valve is on the valve cover approx. 6inches to the driver side from the oil filler cap
Forum: Acura Integra
04-02-2008, 08:50 PM
Replies: 3
Views: 278
Posted By silverAC

sierrahiker8 did you ever sort out that blower...

sierrahiker8 did you ever sort out that blower motor/radio thing?
Forum: Acura Integra
04-01-2008, 10:55 PM
Replies: 9
Views: 733
Posted By silverAC

maybe the internals for a lock switch are worn...

maybe the internals for a lock switch are worn and easily make contact on the lock side. Try engaging the parking brake with the button pushed in so that it doesn't click. if your doors don't lock...
Forum: Acura Integra
04-01-2008, 09:09 AM
Replies: 7
Views: 9,461
Posted By silverAC

remove 4 screws from sides of back half of center...

remove 4 screws from sides of back half of center console. Pop out little cover beneath hand brake(in that storage tray). Remove two screws that are reavealed. lift front edge of back half of...
Forum: Acura Integra
03-25-2008, 11:13 AM
Replies: 2
Views: 446
Posted By silverAC

I wouldn't start your car again until you get...

I wouldn't start your car again until you get good info about this. I'm new to motors so I'm not sure, but I think the cam gear is keyed and will only go on the cam one way. If this is true I would...
Forum: Acura Integra
03-25-2008, 09:15 AM
Replies: 17
Views: 2,140
Posted By silverAC

Re: (AnthonyG)

Alright, first question. Have you used a meter to check for power? A few days ago you knew you were getting power. Now you're not. Not trying to hassle you. Hard to help without good info about...
Forum: Acura Integra
03-25-2008, 08:38 AM
Replies: 2
Views: 521
Posted By silverAC

Are you calling the entire pocket below the radio...

Are you calling the entire pocket below the radio a gap? Are you trying to put the whole changer in there or just keep an extra magazine in there? Are the two grooves sticking out of the pocket or...
Forum: Acura Integra
03-23-2008, 02:38 PM
Replies: 40
Views: 8,797
Posted By silverAC

Re: (silverAC)

Oops. I meant to say i used a socket that was a little to small. If it was to big, you could skip all the hammering.
Forum: Acura Integra
03-23-2008, 02:34 PM
Replies: 17
Views: 2,140
Posted By silverAC

Well call for the code and try entering it. You...

Well call for the code and try entering it. You only need the serial number from the radio. The serial number is on the label. with cassette and cd you probably need to seperate them. the label...
Forum: Acura Integra
03-23-2008, 11:10 AM
Replies: 17
Views: 504
Posted By silverAC

I have seen a dyno sheet for 190hp/NA/b18b1. I...

I have seen a dyno sheet for 190hp/NA/b18b1. I think it was in a thread on TI. If I remember correctly it had a nice wide and flat band of usable torque and kept building hp up to almost 9k. I...
Forum: Acura Integra
03-23-2008, 10:58 AM
Replies: 17
Views: 2,140
Posted By silverAC

you shouldn't have any trouble getting a code. ...

you shouldn't have any trouble getting a code. usually though a Honda radio would say code on the display. if it doesn't light up you wont be able to see the code you are entering. a 96 and 00...
Forum: Acura Integra
03-23-2008, 10:32 AM
Replies: 40
Views: 8,797
Posted By silverAC

I had the same problem. I used a socket that was...

I had the same problem. I used a socket that was a little to big and hammered it on to the lug nut. It took quite a bit of force so i wouldn't try it if you are not confident with a hammer. After...
Forum: Acura Integra
03-23-2008, 08:41 AM
Replies: 26
Views: 7,820
Posted By silverAC

I have a 96. I was having the same issues. I...

I have a 96. I was having the same issues. I just covered the entire car with dynamat. The only parts of the car I didn't cover were the hatch and roof. I have a sunroof so there isn't much metal...
Forum: Acura Integra
03-19-2008, 09:01 AM
Replies: 1
Views: 429
Posted By silverAC

Get a Skewdriver. Home Depot.

Get a Skewdriver. Home Depot.
Forum: Acura Integra
03-15-2008, 06:57 PM
Replies: 8
Views: 882
Posted By silverAC

I couldn't find any obvious things that would...

I couldn't find any obvious things that would cause the radio and blower motor to work (or not) together. I would try to troubleshoot the radio. If there is a common problem between the two, this...
Forum: Acura Integra
03-14-2008, 08:16 AM
Replies: 8
Views: 882
Posted By silverAC

hey man, I haven't forgotton about you. i'm new...

hey man, I haven't forgotton about you. i'm new and my posts are limited to five a day. Is there a way to bookmark a thread? I keep losing you guys because my posting is so limited. Any mods out...
Forum: Acura Integra
03-14-2008, 08:10 AM
Replies: 5
Views: 414
Posted By silverAC

I know the post you refer to and i can't find it...

I know the post you refer to and i can't find it now either. I don't think he ever got an answer though. The post was (Turn signal's dont work?) from n.o.r.e. The apostrophe was in the wrong spot...
Showing results 1 to 25 of 39
 
Page 1 of 2
1
2


 
Forum Jump


All times are GMT -8. The time now is 06:39 AM.