Honda-Tech - Honda Forum Discussion

Notices
 
Page 1 of 4
1
2
3
Last »
Search: Posts Made By: Ubertec
Showing results 1 to 25 of 92
Search took 0.54 seconds.
Forum: Honda CRX / EF Civic (1988 - 1991)
03-15-2009, 06:42 AM
Replies: 11,915
Views: 617,655
Posted By Ubertec

Re: What did you do to your EF today?

Holy crap,Where are we planning on jumpin the civic?
I just finished putting a 8 point in mine but waiting for a swing out for the drivers bar.
Your got one knarly cage there!
Forum: Tech / Misc
12-05-2008, 03:10 PM
Replies: 7
Views: 4,920
Posted By Ubertec

Since it already stripped I say lay it down and...

Since it already stripped I say lay it down and give it some good lovin...dont forget lube
Forum: All Motor / Naturally Aspirated
12-05-2008, 10:47 AM
Replies: 149
Views: 7,595
Posted By Ubertec

Absolutly nothing;)

Absolutly nothing;)
Forum: Forced Induction
12-04-2008, 07:35 PM
Replies: 11
Views: 569
Posted By Ubertec

its the cam profile

its the cam profile
Forum: Forced Induction
12-04-2008, 12:53 PM
Replies: 135
Views: 34,011
Posted By Ubertec

Its a balance between air desity and turbo lag....

Its a balance between air desity and turbo lag. If you want to drag race big turbos make a cooler charge and more cfm. A small turbo can spin so fast that the charge air is so hot it contains less...
Forum: Tech / Misc
12-04-2008, 12:28 PM
Replies: 9
Views: 2,458
Posted By Ubertec

ran low on oil no doubt

ran low on oil no doubt
Forum: Tech / Misc
12-03-2008, 11:17 AM
Replies: 5
Views: 424
Posted By Ubertec

Pull the distributor and check the shaft. 1)does...

Pull the distributor and check the shaft. 1)does it spin round smoothly and 2) is there excessive side to side play?

code 1 is primary o2 sensor.
Forum: Tech / Misc
12-03-2008, 09:53 AM
Replies: 8
Views: 713
Posted By Ubertec

I like the comparison between N/A Honda 100hp per...

I like the comparison between N/A Honda 100hp per liter and the turbo dodge 2.2L.
If you cant make 100hp per liter with forced induction you need to go suck on your exhaust pipe!
Forum: All Motor / Naturally Aspirated
12-03-2008, 07:22 AM
Replies: 27
Views: 6,430
Posted By Ubertec

Not always true. Todays fuel injectors have a...

Not always true. Todays fuel injectors have a wide array of spray patterns and are always getting better. I cant think of one reason to use carbs over efi. Other than not knowing how to tune your...
Forum: Tech / Misc
12-03-2008, 06:28 AM
Replies: 8
Views: 713
Posted By Ubertec

Check this loaf out

http://seductiveautosports.tripod.com/honda%20haters.htm

Duuuhhh!
Forum: All Motor / Naturally Aspirated
11-07-2008, 05:33 AM
Replies: 91
Views: 16,856
Posted By Ubertec

Re: (Joseph Davis)

Its about 9.0:1 @ 6500ft and LS Vtec/ gsr cams. It's the only NA car I have right now but Im pretty shur h2o works best with lower compression cars from some other info (some guy...
Forum: All Motor / Naturally Aspirated
11-06-2008, 03:15 PM
Replies: 91
Views: 16,856
Posted By Ubertec

Re: (Joseph Davis)

Colorado Springs CO 85,87,91 and E85 because of the altitude.Im soon to be tuning my water ethanol system using 85 and seeing if I can run the same ignition as the 91 where I'm street tuned now....Or...
Forum: Honda CRX / EF Civic (1988 - 1991)
09-24-2008, 06:23 AM
Replies: 24
Views: 848
Posted By Ubertec

Re: Which Limited slip set up should I use (dr_latino999)

Mfactory has a new gear type LSD for 650.00 and they make good shit.
OBX = CRAP
phantom grip is 300.00 for way less performance.
Forum: Forced Induction
12-17-2007, 05:52 AM
Replies: 15
Views: 748
Posted By Ubertec

Re: Opinions and Suggestions on Nitrous (poweroftheblah)

Jets don't cost much ,start with a 20 or 30 shot untill your comrortable with the way it runs and go up from there. Look up the fuel to nos tables from differant manufacturers on the web, also if you...
Forum: Forced Induction
10-19-2007, 07:22 AM
Replies: 29
Views: 4,517
Posted By Ubertec

Re: (boosted k20)

As far as eCtune goes the ostrich pairing is in its final stages, The tuners are testing it and trying to find ways around it right now. I'm looking for clients in colorado to test. At least the wiki...
Forum: Forced Induction
09-21-2007, 06:08 AM
Replies: 27
Views: 2,198
Posted By Ubertec

Re: (JaredKaragen)

If it uses a vacuum diaphram to hold the throttle open then positive pressure will have the opposite effect. The boost will fill the diaphram and will not hold the throttle open, unless you had a...
Forum: Forced Induction
07-25-2007, 08:08 AM
Replies: 3
Views: 446
Posted By Ubertec

Re: Should I raise fuel pressure 5 psi for nitrous????????????????? (integrawow)

More important that your fuel pump can supply the demand, if it can then you should'nt get any pressure drop.
Forum: Forced Induction
07-04-2007, 09:18 AM
Replies: 34
Views: 25,716
Posted By Ubertec

Re: Tuners: How long does it take you to tune a car? (blackeg)

Long enough to make it right ,no more ,no less. https://honda-tech.com/forums/images/smilies/emwink.gif
Forum: Forced Induction
06-29-2007, 01:50 PM
Replies: 4
Views: 308
Posted By Ubertec

Re: Turbo Question? (hotimportcrx)

T28 would be good too! t28r better!
Forum: Honda CRX / EF Civic (1988 - 1991)
06-29-2007, 01:46 PM
Replies: 35
Views: 1,783
Posted By Ubertec

Re: (civic_jdm16)

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by civic_jdm16 &raquo;</TD></TR><TR><TD CLASS="quote">There are 5 main things that cause Vibration..... ...
Forum: Forced Induction
06-29-2007, 01:20 PM
Replies: 4
Views: 329
Posted By Ubertec

Re: I'm looking for a thread on nitrous (Del Sol on Steroids)

Alot less cylinder pressure to get the same oxygen suppliment! A regular atmoshere is 19% oxygen and 80% nitrogen, Nos is more like 30%oxygen. Nitrous dos'nt mind timing like boost but requires the...
Forum: Forced Induction
06-29-2007, 10:30 AM
Replies: 1
Views: 278
Posted By Ubertec

Re: turbo and nos set up (eglslsd)

Absolutely! https://honda-tech.com/forums/images/smilies/emthup.gif
Forum: Forced Induction
06-28-2007, 01:45 PM
Replies: 13
Views: 1,175
Posted By Ubertec

Re: (Max500)

"All our Nozzles have a 1/8" NPT male threads " quoted off the web site you linked

I bet if you screwed it into a 1/8 NPT female thread it would work...
Forum: Forced Induction
06-28-2007, 11:49 AM
Replies: 17
Views: 2,499
Posted By Ubertec

Re: (I.C.C.)

Warm it up and wiggle the intake part of the turbo, see if it has play.
Forum: Forced Induction
06-22-2007, 08:58 AM
Replies: 15
Views: 644
Posted By Ubertec

Re: What Kind of race gas to run.. (Sean18337)

No but I know that in the 80 formula 1 cars ran on like 87 or so % tolulene.
I plan on doin some experiments.
Showing results 1 to 25 of 92
 
Page 1 of 4
1
2
3
Last »


 
Forum Jump


All times are GMT -8. The time now is 06:06 AM.