Notices
 
Search: Posts Made By: honda_luvr_2000
Showing results 1 to 25 of 167
Search took 0.67 seconds.
08-29-2010, 09:21 PM
Replies: 23
Views: 7,535
Posted By honda_luvr_2000

Re: EMERGENCY!! Car Wobbles like crazy

Does it shake when accelerating hard up to 50mph?
If you aren't getting any shaking in the steering wheel, and it feels like it is coming from the front, then it sounds like bad axles (mainly bad...
08-29-2010, 09:03 PM
Replies: 4
Views: 2,231
Posted By honda_luvr_2000

Re: B16a3 Del Sol timing Belt due

It's overkill for a factory/stock engine. Overkill in the sense that the factory timing belt will do just fine on a factory/stock engine. It won't hurt anything to use it on a factory/stock engine,...
08-29-2010, 08:57 PM
Replies: 4
Views: 1,900
Posted By honda_luvr_2000

Re: EG t bracket , half shaft HELp

T-bracket bolts & washers part numbers:
rear bolt= 90165-S04-000, washer= 90505-SB2-000
front bolt= 90190-SR3-000, washer= 90505-SB2-000
two bottom bolts= 90188-SR3-010, washers= 90505-SR3-000...
08-29-2010, 08:47 PM
Replies: 6
Views: 3,237
Posted By honda_luvr_2000

Re: B16 Tranny Noises Help

Does the sound occur in & out of gear? Does it only occur when you press the clutch pedal to the floor? Does the sound occur only on decel, but not on accel or steady cruise? At this point it could...
Forum: Tech / Misc
06-14-2010, 11:37 PM
Replies: 2
Views: 743
Posted By honda_luvr_2000

Re: How much is this ecu worth? Pictures included.

The harness is an OBD2B to OBD2A conversion harness (OBD2B vehicle to OBD2A computer).
The computer is worth what ever someone is willing to pay for it. For example, I don't have much use for it, so...
Forum: Tech / Misc
06-14-2010, 11:25 PM
Replies: 9
Views: 3,519
Posted By honda_luvr_2000

Re: shift linkage problems

Glad to hear it's fixed.
06-14-2010, 11:17 PM
Replies: 19
Views: 12,349
Posted By honda_luvr_2000

Re: d16z6 wont rev over 2500, tried everything HELP!!!

I have a question... Why did you do the CKF sensor bypass?
You have an OBD1 computer that won't even be looking for the CKF sensor. And YES all OBD1 engines have a crank position sensor. They do...
Forum: Tech / Misc
06-10-2010, 08:46 PM
Replies: 4
Views: 717
Posted By honda_luvr_2000

Re: alternator problem

If the engine shuts right off as soon as you turn on the A/C, sounds like the problem is with the A/C compressor, not the alternator. If it has no running problems with the A/C off, headlights on,...
Forum: Tech / Misc
06-10-2010, 08:43 PM
Replies: 11
Views: 828
Posted By honda_luvr_2000

Re: is this possible?

It seems everybody forgot something here...
Honda radiators are designed to and do "flow" top to bottom. The hot coolant comes in the top of the radiator, and, when the thermostat opens, cooler...
06-10-2010, 02:34 PM
Replies: 8
Views: 8,212
Posted By honda_luvr_2000

Re: Air conditioning issues *detailed symptoms.

The pressure switch is separate from the compressor.
You said you had a fluid leak near front of car that wasn't coolant or water. A low charge will cause the A/C to be inefficient.
The pressure...
Forum: Tech / Misc
06-09-2010, 10:30 AM
Replies: 9
Views: 9,551
Posted By honda_luvr_2000

Re: Melted Valve Issue. Please Help

Do a compression test across all 4 cylinders at both cold & operating temperature (like spanky_1 said) after you do the repair. I would have said to do a complete compression test on the engine...
Forum: Tech / Misc
06-08-2010, 09:17 PM
Replies: 4
Views: 2,275
Posted By honda_luvr_2000

Re: ANY HELP WOULD BE APPRECIATED. CIVIC EK DIES WHEN STOPPED

Yes the loose battery terminal clamp can cause odd problems. Bad battery would cause a no start, not a stalling problem. Bad alternator would also cause a no start problem because you would have...
06-08-2010, 08:56 PM
Replies: 30
Views: 2,861
Posted By honda_luvr_2000

Re: Serious help needed.

If you're going to give info, try to give as much correct detail as possible...

P28 (92-95 Civic Si/EX) base ignition timing is 16 +/-2 degrees BTDC (Before Top Dead Center) at idle with no load &...
Forum: Tech / Misc
06-08-2010, 03:21 PM
Replies: 9
Views: 9,551
Posted By honda_luvr_2000

Re: Melted Valve Issue. Please Help

Burnt exhaust valve... Well valve clearance too tight on an exhaust valve can cause that.
An exhaust leak very close to the cylinder head can cause an exhaust valve to burn. From how it's been...
Forum: Tech / Misc
06-08-2010, 11:02 AM
Replies: 26
Views: 2,892
Posted By honda_luvr_2000

Re: Need help with Random Power Loss

If the engine itself didn't seem to follow the 1000 RPM drop on the tach, then I'd say you have an RPM signal or tachometer problem. If the engine did drop RPM (only going to know by sound frequency...
06-08-2010, 10:46 AM
Replies: 2
Views: 1,166
Posted By honda_luvr_2000

Re: B18C-R swap

Make sure you get a half shaft for a 5 speed B series and NOT an automatic. The auto will NOT fit with the 5spd trans. You can use the axles & half shaft from any of the following vehicles:
94-01...
06-08-2010, 10:15 AM
Replies: 9
Views: 966
Posted By honda_luvr_2000

Re: cel light help

Yes you can hook up a scan tool to an OBD1 Honda (as long as the vehicle was originally OBD1).


Yes.
Often the ECU will store the code even if the CEL is off, however there are times that it...
06-08-2010, 10:06 AM
Replies: 7
Views: 16,961
Posted By honda_luvr_2000

Re: brake lines help asap

It is a double flare. I know for a fact. I have had two friends replace brake line sections in Civics. Both of them did the double flare and neither of them have had a problem. One going on three...
06-08-2010, 09:58 AM
Replies: 8
Views: 8,212
Posted By honda_luvr_2000

Re: Air conditioning issues *detailed symptoms.

Sounds like you may have two problems.
The residue on the front of the car, where exactly is it? Depending on where the residue is, it may be an A/C system charge leak.
The squeal noise you're...
06-08-2010, 09:49 AM
Replies: 30
Views: 2,861
Posted By honda_luvr_2000

Re: Serious help needed.

spark "ignition" advance all depends on RPM. So unless you know what the advance is supposed to be at different given RPM's then that's not so easy to determine.

edit:
The CKP (CranK Position)...
Forum: Tech / Misc
06-04-2010, 09:26 PM
Replies: 9
Views: 5,128
Posted By honda_luvr_2000

Re: B20b4 HELP PLEASE!!

Nominal: 178 PSI
Minimum: 135 PSI
Maximum variation between any two cylinders: 28 PSI
06-04-2010, 08:40 PM
Replies: 30
Views: 2,861
Posted By honda_luvr_2000

Re: Serious help needed.

Your photos that you posted show two things...
1st: The distributor harness plug is in fact an OBD2A 10 pin 9 wire connector.
2nd: The 100% stock engine harness has in fact had the original OBD2B...
06-03-2010, 08:02 PM
Replies: 30
Views: 2,861
Posted By honda_luvr_2000

Re: Serious help needed.

Here are the wire colors and pin locations for both sides (distributor connector & engine harness connector) of the OBD2A & OBD2B distributor connectors.

OBD2A: 10 pin connector with 9 wires...
06-03-2010, 07:35 PM
Replies: 17
Views: 7,972
Posted By honda_luvr_2000

Re: clutch line prop valve?

For real dude, did you read anything I said? I already explained what it was by its correct name. Also I asked what car, "Civic" isn't very specific. If it's a 92-95 then yes it has it too. If it's...
06-03-2010, 07:30 PM
Replies: 5
Views: 3,279
Posted By honda_luvr_2000

Re: Eacv/Iacv hoses not connected??? help

If it's bypassed, you can't.
Showing results 1 to 25 of 167
 


 
Forum Jump


All times are GMT -8. The time now is 08:32 AM.