Notices
 
Search: Posts Made By: sw388
Showing results 1 to 25 of 62
Search took 0.95 seconds.
03-01-2012, 01:30 PM
Replies: 42
Views: 37,071
Posted By sw388

Re: Leaking B16

I agree with Cap'N Chronic.....Diagnose before you start jumping to speculations. Whats the history of this car....did you just buy it and notice the leak? or not did you bottom out your car ever? It...
03-01-2012, 12:28 PM
Replies: 43
Views: 13,130
Posted By sw388

Re: b16a Em1

What's your elevation? I was able to hit 15.7 with a stock 96 LS on falken azenis @2,389 ft years ago. I always liked a B16....I felt it was always underestimated. Simply put the rod to stroke ratio...
02-24-2012, 12:58 PM
Replies: 5
Views: 926
Posted By sw388

Re: throttle cable

I would say a P73(ITR) cable stay and cable. I have used an ls cable w/p73 cable stay and it worked too.
02-24-2012, 12:53 PM
Replies: 2
Views: 1,374
Posted By sw388

Re: Which jumper harness should i use

Its not looking good. check these links out.

http://technet.ff-squad.com/wiring.obd2b.htm

http://technet.ff-squad.com/wiring.obd2a.htm
02-24-2012, 12:39 PM
Replies: 7
Views: 2,220
Posted By sw388

Re: Transmission

My money is on the throwout bearing. Typically those noise are alleviated when a clutch kit is installed (replaced bearings: Pilot bearing and throwout bearing). I have not encountered the input...
02-24-2012, 12:25 PM
Replies: 1
Views: 1,604
Posted By sw388

Re: Help with trailing arm

Just a shoot in the dark here, with no facts. I would assume Integra rear trailing arms.....they are the most commonly available rear disc upgrade. I have not measured but im sure the part numbers...
02-24-2012, 12:21 PM
Replies: 45
Views: 75,138
Posted By sw388

Re: shifter loose, bushing or linkage??

At times the shift rod will go bad you may need to get under there and watch the movement while a friend changes gears or moves it to identify if the joints at the end of the shift rod are bad. I...
07-29-2011, 10:08 AM
Replies: 33
Views: 6,320
Posted By sw388

Re: 97 d16y8 diff 00 d16y8

FYI the 97 is OBD-IIa and 00 is OBD-IIb...But it looks like you have bigger fish to fry with the intake mani and head swap. good luck!!!
07-28-2011, 09:05 AM
Replies: 7
Views: 23,549
Posted By sw388

Re: Does an eg hatch exhaust fit the ek hatch?

I swapped my K-teller 3in from EG to EK without any issues.
07-28-2011, 08:52 AM
Replies: 18
Views: 12,313
Posted By sw388

Re: Changes for better gas mileage?

An alignment is key if its not already done and tire pressure for a combo of less rolling resistance. I miss driving VX's shift light FTW!!!
07-28-2011, 08:41 AM
Replies: 24
Views: 10,312
Posted By sw388

Re: How difficult is it to replace rack-n-pinion on an EJ1?

^^ yes sir!! good luck. I was fortunate last time I replaced a rack, the engine was out and it was a DX model.
07-28-2011, 08:33 AM
Replies: 23
Views: 11,204
Posted By sw388

Re: Vtec not working; b18c swap

I have never done this but I have heard of testing the solenoid by running a power wire to manually test the functionality. again never done it....I just have extra solenoids to test thank goodness.
07-28-2011, 08:16 AM
Replies: 23
Views: 11,204
Posted By sw388

Re: Vtec not working; b18c swap

Have you verified your vtec wiring you added? (assuming you dont have an SI) Lets hope its got a good ground, and its pin'd correctly
07-27-2011, 09:34 AM
Replies: 2
Views: 510
Posted By sw388

Re: Timing issue?

any CEL's? If none try adjusting the idle screw(counterclockwise)....if you have any extra throttle bodies laying around swap the part to eliminate the TPS as an issue. Hopefully you have some cel's...
07-27-2011, 09:24 AM
Replies: 10
Views: 57,810
Posted By sw388

Re: Rattle Sounds Only Accelerating.

I have a similar issue...AC tensioner pulley but I have yet to fix it... Im with Wrona on this one...what are we looking at? If it was a civic draging some coke cans with just married tagged on the...
07-27-2011, 09:13 AM
Replies: 7
Views: 6,678
Posted By sw388

Re: 92 civic si hatch fuel pump not priming

Sounds.....like the relay as sowellman88011 stated, along with your no clicks symptom
07-07-2011, 09:06 AM
Replies: 22
Views: 2,440
Posted By sw388

Re: what clusters fit 2000 si?

Just ask a friend (with an EK or CRV 95-01) as kaiba stated to help you out and swap clusters to eliminate the cluster being an issue. If ur doin 45 mph in first gear ur shit may be *ucked!!!
07-07-2011, 08:57 AM
Replies: 2
Views: 1,027
Posted By sw388

Re: b18C eg CEL problum.

lets poke at the fuel delivery. Have you changed the fuel filter? It could be a bad regulator in turn the O2 would pick up lean or rich.....with that being said the O2 could be an issue as well....
Forum: Performance
06-09-2011, 07:14 AM
Replies: 41
Views: 10,473
Posted By sw388

Re: MARSHALL FUEL PRESSURE GAUGE 0-100 psi LIQUID FILLED $ 27.95 SHIPPED

Received the goods 2 days later!!!!! Great service, Thank you.
02-26-2011, 02:52 PM
Replies: 2,032
Views: 181,643
Posted By sw388

Re: "You know you own an EG, EK when ..."

-when you no longer take your car to 'go out' because you can't leave it anywhere unattended or it will be gone when you get back from dinner w/your chick.

-when your co-workers slam the door shut...
Forum: Acura Integra
02-25-2011, 10:44 AM
Replies: 28
Views: 28,726
Posted By sw388

Re: 95 rs integra running rich, any ideas?

I would have to agree with everyone o2 sensor. The sensor is probably bad and the ECU is running at a continuous ‘open loop’ state burning more fuel then needed. Here's a long shot, an injector...
Forum: Acura Integra
02-25-2011, 10:30 AM
Replies: 1
Views: 756
Posted By sw388

Re: Question about replacing Vtec Solenoid Gastket

well the facts are; im sure the previous individual who assembled the head used RTV from a local auto parts store. The proper silicon sealant would be hondabond. It hovers above 15 bucks a tube from...
02-25-2011, 10:17 AM
Replies: 9
Views: 7,714
Posted By sw388

Re: Tips for Lower Ball Joint Change

its frowned upon, but I knocked them out with a hammer quite easily so I did not need a press to press them in, just used wood to spread out the impact of the blow to the ball joint. Oh dont forget...
02-25-2011, 09:51 AM
Replies: 27
Views: 3,931
Posted By sw388

Re: 1992 civic vx?

^^thats a good feeling. Gas is now 3.50 for 87 where I'm located.(AZ)
Showing results 1 to 25 of 62
 


 
Forum Jump


All times are GMT -8. The time now is 09:21 AM.