Honda-Tech - Honda Forum Discussion

 
Page 1 of 9
1
2
3
Last »
Search: Posts Made By: TPB
Showing results 1 to 25 of 208
Search took 1.16 seconds.
Forum: Suspension & Brakes
08-05-2015, 07:03 PM
Replies: 10
Views: 1,571
Posted By TPB

Re: itr master cyl in a eg

just bend carefully by hand
Forum: Suspension & Brakes
06-28-2015, 07:53 AM
Replies: 4
Views: 752
Posted By TPB

Re: Improve Dampening for High Speed Stability

Those spring rates are beyond the functional capability of your dampers. If you're not prepared to match the correct dampers with those springs, reduce the spring rates.
Forum: Suspension & Brakes
05-02-2015, 08:31 AM
Replies: 28
Views: 9,144
Posted By TPB

Re: Took my diy alignment setup to the next level...

Great method that also brings closer to level an inevitably unlevel surface. I've been using plastic grocery bags under the tires which have worked great in the past but don't take it the one step...
Forum: Suspension & Brakes
04-29-2015, 05:38 PM
Replies: 6
Views: 617
Posted By TPB

Re: SOO besides an aftermarket BBK

Your tires are the limiting factor for stopping power in a street car, not bigger brakes.
Forum: Suspension & Brakes
03-31-2015, 05:52 PM
Replies: 8
Views: 7,429
Posted By TPB

Re: Brake Hard Line Replacement

If it's anything like the EG which it looks to be, you'll need to remove the front subframe to install the lines... it's a big job so make sure that is your problem before you proceed.
Forum: Suspension & Brakes
03-23-2015, 08:46 AM
Replies: 18
Views: 2,932
Posted By TPB

Re: Higher spring rates. What means?

To answer the OP's question, if the springs you are comparing are the same length, the car will experience similar handling characteristics as before (maybe a little more understeer) although the...
Forum: Suspension & Brakes
03-22-2015, 12:45 PM
Replies: 18
Views: 2,932
Posted By TPB

Re: Higher spring rates. What means?

Because it fails to acknowledge spring length or perch height which can vary considerably.
Forum: Suspension & Brakes
12-29-2014, 09:42 AM
Replies: 25
Views: 2,517
Posted By TPB

Re: Comparing Skunk2 UCAs

I've used the S2 front uca's since 2005 on both my DC and EG in 1-3 hour races and never had an issue with them.
Forum: Tech / Misc
12-03-2014, 11:57 AM
Replies: 7
Views: 6,670
Posted By TPB

Re: Building / bending your own hard lines for fuel and turbo oil feed...

Wrap your lines in Aeroquip fire sleeve. You can buy it by the inch from many race supply stores. It isn't cheap but it's a lot easier than re routing fuel and oil lines.
Forum: Suspension & Brakes
11-28-2014, 09:46 AM
Replies: 26
Views: 3,214
Posted By TPB

Re: ITR brakes w/hawk "blues" vs Wilwood dynalite 4 piston 12.2

Are you having issues with your current set up? Depending on where you're planning on running (track) and duration of sessions, you might just consider switch to another pad compound since the ITR...
Forum: Road Racing / Autocross & Time Attack
09-30-2014, 10:21 AM
Replies: 13
Views: 1,114
Posted By TPB

Re: Quaife Steering rack issue locking up in high speeds around corners

Which corner did this occur in? Assuming this was on the GP track if you're going through the corner at 120kmh. Was it full lock to the right when it occured?
Forum: Suspension & Brakes
09-07-2014, 02:31 PM
Replies: 3
Views: 1,088
Posted By TPB

Re: New brake and fuel lines

You need to drop the subframe
Forum: Road Racing / Autocross & Time Attack
08-15-2014, 02:41 PM
Replies: 7
Views: 2,028
Posted By TPB

Re: slightly confused

I would reco using a 4 pole master switch
Forum: Tech / Misc
07-28-2014, 06:29 PM
Replies: 3
Views: 1,303
Posted By TPB

Re: Placement of Honda Bond/RTV??

Between gasket and head
Forum: Road Racing / Autocross & Time Attack
07-02-2014, 09:12 AM
Replies: 5
Views: 914
Posted By TPB

Re: where to buy os giken

Try Carl at Perry Performance in Laval
Forum: Tech / Misc
06-29-2014, 05:55 AM
Replies: 1
Views: 797
Posted By TPB

Re: whats this wire integra headlight plug

Sorry but working from limited memory when I completely reworked all the wiring in my car a few years ago... it might be for the brake lights.
Forum: Tech / Misc
05-31-2014, 07:00 AM
Replies: 6
Views: 10,800
Posted By TPB

Re: What is the correct method to bleed all air from cooling system?

Only thing the shop left out was jack the front of your car as high as you can to help bleed the system of all air bubbles while running engine
Forum: Road Racing / Autocross & Time Attack
03-09-2014, 05:30 AM
Replies: 53
Views: 8,661
Posted By TPB

Re: TrackJack, new portable lift

Found this on another forum...looks like a great product


QuickJack - for those of you wondering
Hey all.

Sorry for being AWOL. Been very busy working on the re-design and have been living...
Forum: Road Racing / Autocross & Time Attack
02-16-2014, 06:34 PM
Replies: 7
Views: 809
Posted By TPB

Re: Help me pick a helmet for this season ?

I suggest you go to CSC Racing and have Jennifer fit you properly for a helmet. Many Ontario competitors have bought from them (I've bought 3 helmets over the years from them) and they are very...
Forum: Tech / Misc
02-08-2014, 06:09 AM
Replies: 7
Views: 1,629
Posted By TPB

Re: Double Flaring tools

Mastercool Hydraflare!
Forum: Road Racing / Autocross & Time Attack
10-31-2013, 05:04 PM
Replies: 230
Views: 30,799
Posted By TPB

Re: Track Video(s) Too Good Not to Share...

That seemed unnecessarily risky for the passenger, not to mention everyone else participating on the track.
Forum: Road Racing / Autocross & Time Attack
10-22-2013, 08:11 PM
Replies: 10
Views: 1,419
Posted By TPB

Re: Engine Question for road racers

Your options depend on what the rule set for the race series you're considering allows
Forum: Road Racing / Autocross & Time Attack
09-10-2013, 05:36 PM
Replies: 11
Views: 1,775
Posted By TPB

Re: Any suggestions for a muffler?

I think a major contributor to the high dB level is that the track is mostly WOT, averaging over 90mph.
Forum: Road Racing / Autocross & Time Attack
09-09-2013, 06:15 PM
Replies: 11
Views: 1,775
Posted By TPB

Any suggestions for a muffler?

I'm running a 3" exhaust on my k swap EG. I have a three hour race coming up very soon and I really don't want to go deaf over the course of 3 hours. I can't wear foam earplugs because I have moulded...
Showing results 1 to 25 of 208
 
Page 1 of 9
1
2
3
Last »


 
Forum Jump


All times are GMT -8. The time now is 04:48 AM.