Notices
 
Search: Posts Made By: slowpokesi
Showing results 1 to 25 of 408
Search took 3.13 seconds.
04-28-2015, 08:54 PM
Replies: 8
Views: 585
Posted By slowpokesi

Re: itr will not hold idle, need help!

The map and tps use the same style connector and they are right next to each other. I had a similar issue and after troubleshooting, i plugged the wrong connectors in, switched them around good to...
04-27-2015, 07:42 PM
Replies: 18
Views: 2,441
Posted By slowpokesi

Re: 2000 CIVIC SI EM1 Turbocharged VERY CLEAN

Questions:
Ac?
Salvage?

Free Bump
04-27-2015, 07:23 PM
Replies: 1
Views: 1,641
Posted By slowpokesi

Re: 92 eg, b series, aem intake... where to put radiator overflow

https://cimg9.ibsrv.net/gimg/honda-tech.com-vbulletin/2000x1504/80-aem_img_0264_c3d1edf605725da51a375569fc12dc732ff940e9.jpg


Photo for reference In this pic, its just sitting in the whole above...
04-27-2015, 07:12 PM
Replies: 1
Views: 1,641
Posted By slowpokesi

92 eg, b series, aem intake... where to put radiator overflow

Where should my radiator overflow go? I dont have the factory mount. I have the aem intake v1 for hybrid swaps and the tank has no where to live. I've done some searching and most people put it in...
04-27-2015, 07:03 PM
Replies: 6
Views: 781
Posted By slowpokesi

Re: Failing Emissions

Installed the new ecu, but the weather was bad so i couldn't take it for a spin. I've got 13 days to reinspect it and pass or I get to pay all over again :hammer:
04-26-2015, 05:51 PM
Replies: 8
Views: 585
Posted By slowpokesi

Re: itr will not hold idle, need help!

Make sure you didn't swap the map and tips sensor plugs.... I did and had the exact symptoms w/ no cel.
04-26-2015, 01:43 PM
Replies: 6
Views: 781
Posted By slowpokesi

Re: Failing Emissions

Oil is fresh, less than 20 miles. I went ahead and put in a new pcv valve. Ecu should get here tomorrow.
04-25-2015, 08:28 AM
Replies: 6
Views: 781
Posted By slowpokesi

Failing Emissions

Backstory... Car has sat in storage for 10 years, pulled it out of storage and finally started working on it.

92 civic si with a freshly swapped b16B swap, using the JDM harness, we extended the...
04-12-2015, 04:34 PM
Replies: 4
Views: 763
Posted By slowpokesi

Re: Help tracking down leak

Distributer, vtec gasket, cam seal are bone dry. I've got some oil on the filter housing, and this black box next to the filter. I'm guessing the oil cooler gasket might be the culprit. Still...
04-12-2015, 02:32 PM
Replies: 4
Views: 763
Posted By slowpokesi

Help tracking down leak

I've been dripping quite a bit of oil from the inspection plate cover on the tranny / block (B16b / LSD Tranny). I'm not sure if its transmission fluid or oil but it's more than just a drip its a...
03-25-2015, 03:52 AM
Replies: 17
Views: 2,376
Posted By slowpokesi

Re: Camshaft killing my Dizzy?

Man.... Glad you sorted it out. That sucks about getting rear ended.
03-24-2015, 08:35 PM
Replies: 19
Views: 1,077
Posted By slowpokesi

Re: b16a swap questions

All that you should need to know is here...
https://honda-tech.com/honda-crx-ef-civic-1988-1991-3/b16a-crx-swap-guide-1193782/

I even went back and fixed most of the pics!!! Goodluck.
03-24-2015, 06:38 PM
Replies: 47
Views: 120,341
Posted By slowpokesi

Re: B16a Crx Swap Guide

I love how honda-tech is a time capsule of information. It has been several years since i wrote this article and I'm glad to see that it is still in use. I'm very sorry about the pics though :(
...
03-23-2015, 12:47 PM
Replies: 15
Views: 1,834
Posted By slowpokesi

Re: del Sol No Start

holy shit!!! I don't beleive that could have ever ran that way. What likely happened based on your description is that it was hooked up properly and something caused the belt to jump teeth. Either...
03-21-2015, 10:48 PM
Replies: 3
Views: 649
Posted By slowpokesi

Re: Engine stalling... WTF!!

I had the exact same issue, make sure your tps and map sensor plugs are not swapped. After a week of troubleshooting a million things it turned out i had the wrong plugs on these 2 sensors (they...
03-21-2015, 08:15 PM
Replies: 8
Views: 598
Posted By slowpokesi

Re: Problem w/ new swap

Drained gas, changed out the fuel filter, put in new plugs.... Fired it up, no Bueno. Did some more searching and came across someone mentioning recalibrate the tps. Instead of that I just swapped...
03-19-2015, 09:32 PM
Replies: 8
Views: 598
Posted By slowpokesi

Re: Problem w/ new swap

Gauge says i have about 1/4 of a tank. I guess it's possible that the gauge is off. I will try putting in another 2 gallons. I'm cautious to fill it up in the event that i need to drain it.
03-19-2015, 09:04 PM
Replies: 21
Views: 8,116
Posted By slowpokesi

Re: no power to starter 99 civic ex

http://photos.napalm.net/clubsi/clutchswitch.jpg
03-19-2015, 08:34 PM
Replies: 8
Views: 598
Posted By slowpokesi

Problem w/ new swap

Backstory:
92 EG hasn't been driven since sometime in 2004, previous owner spun a bearing in the b18c5 that was swapped in it. It sat in storage for about 5 years and its been in my garage now for...
03-19-2015, 08:33 PM
Replies: 21
Views: 8,116
Posted By slowpokesi

Re: no power to starter 99 civic ex

The high one is busted. That's your problem. Unhook the cable and jump it with some copper and try it. I literally just had the same problem not even an hour ago. I guess thats what happens when...
03-19-2015, 08:19 PM
Replies: 21
Views: 8,116
Posted By slowpokesi

Re: no power to starter 99 civic ex

I literraly just had this problem on my hatch. After pushing it up hill into my garage, came online found this exact same answer, sure enough the rubber plug was broken off. Wish i would of checked...
07-16-2013, 05:24 AM
Replies: 5
Views: 675
Posted By slowpokesi

Need to bounce some ideas..

I've got a 92 si hatch in my garage with a jdm b18c that is knocking. Long story short the previous owner spun a bearing, he stopped making payments on the car and the car was repo'd. My buddy's...
Forum: South
07-14-2013, 09:35 PM
Replies: 112
Views: 25,504
Posted By slowpokesi

Re: Meets..........DFW, Central TX, houston on going, i need your help!

Can anyone recommend a local machine shop in Dallas?

My buddy gave up on his project car and signed it over to me. I need to have the bottom end rebuilt due to a spun bearing. I can do quite a...
Forum: For Sale
08-28-2009, 01:30 PM
Replies: 0
Views: 575
Posted By slowpokesi

FS: Honda JDM P72 GS-R ECU and OBD2a - OBD2b adapter harness

$325 - located in Denton, TX

The purchase of this package will fix the wiring problems resulting from the swap you were so excited to have. You'll have your VTEC back.

This is a Honda OBD2a JDM...
04-26-2009, 07:46 AM
Replies: 97
Views: 7,339
Posted By slowpokesi

Re: Build of ma civic (transformer)

Actually, lambo's do still have lambo doors. Gallardo's do not but Murcielago' do.
http://www.pspsonywallpaper.com/wp-content/uploads/2007/04/lamborghinimurcielago.jpg
Showing results 1 to 25 of 408
 


 
Forum Jump


All times are GMT -8. The time now is 02:25 AM.