Odyssey automatic sliding door
#1
Honda-Tech Member
Thread Starter
Join Date: Sep 2008
Location: seattle, wa
Posts: 107
Likes: 0
Received 0 Likes
on
0 Posts
Odyssey automatic sliding door
The left side of my Odyssey automatic sliding door doesnt work, Its a 2001 Odyssey.
I checked the fuses and they are all good, the left side doesnt work but the other side does.
I checked the fuses and they are all good, the left side doesnt work but the other side does.
#2
Re: Odyssey automatic sliding door
i have the same problem, i also checked the fuses. I going to start be changing the switch to see if that does anything. You can aslo check here http://www.odyclub.com/
#3
Re: Odyssey automatic sliding door
i have a 01 too. there sliding doors are the most problematic doors in the world. Mine have amind of there own. some days they works others they dont.
#4
Honda-Tech Member
Join Date: Jan 2009
Location: Cedar Rapids Iowa
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
Re: Odyssey automatic sliding door
on the pass side kick panel there is a fuse labled back up..its a 7.5 amp fuse i believe. pull that fuse for about 30 seconds and reinstall it..that will reset the computer for the sliding doors and both doors will work again. also one this to make sure is that all door seals are cleaned, honda make a rubber care product that works great. this will prevent your doors from going into safety mode.
#5
Re: Odyssey automatic sliding door
on the pass side kick panel there is a fuse labled back up..its a 7.5 amp fuse i believe. pull that fuse for about 30 seconds and reinstall it..that will reset the computer for the sliding doors and both doors will work again. also one this to make sure is that all door seals are cleaned, honda make a rubber care product that works great. this will prevent your doors from going into safety mode.
#6
In a Junkyard near you.
Re: Odyssey automatic sliding door
Pull off the b-pillar trim on both sides and make sure that ground is good. If you think it might be bad just install a star washer between the wire and body (scrape off any paint to bare metal). There is a service bulletin for this.
Thread
Thread Starter
Forum
Replies
Last Post