pulley stuck
#1
Honda-Tech Member
Thread Starter
Join Date: Oct 2006
Location: Margaritaville, USA
Posts: 756
Likes: 0
Received 0 Likes
on
0 Posts
pulley stuck
When replacing the auto tensioner I took off the crankshaft pulley. Put the new tensioner in no problem but when I put the crankshaft pulley back on I noticed it wasn't spinning. So I took the pulley and lower cover back off and the pulley directly behind the crank shaft pulley is pushed back into my timing belt. How can I get this pulley pulled off? Any ideas? I believe it's called the balancer belt pulley?
#2
Honda-Tech Member
Join Date: Jan 2007
Location: baltimore, md
Posts: 406
Likes: 0
Received 0 Likes
on
0 Posts
Re: pulley stuck
Looking over the schematic i dont see anything holding it in place, so it should slide off.
Crank>>timing belt guide plate>>>timing belt drive pulley>>>>balancer belt drive pulley>>>crankshaft pulley. They of course you have the key. That's the order.
Try some penetrating oil, it may be alittle rusted up. And twist as you pull forward.
Crank>>timing belt guide plate>>>timing belt drive pulley>>>>balancer belt drive pulley>>>crankshaft pulley. They of course you have the key. That's the order.
Try some penetrating oil, it may be alittle rusted up. And twist as you pull forward.
Thread
Thread Starter
Forum
Replies
Last Post