Which platigage should I use...?
#1
Honda-Tech Member
Thread Starter
Join Date: May 2006
Location: Road rage, state, us
Posts: 383
Likes: 0
Received 0 Likes
on
0 Posts
Which platigage should I use...?
I'd like to know which plastigage should I use to ckeck the oil clearance for the main and rod bearings? The reason I ask is because there are red, blue and green ones, I believe.
Thanks.
Thanks.
#2
Honda-Tech Member
Join Date: Apr 2009
Location: So Cal
Posts: 417
Likes: 0
Received 0 Likes
on
0 Posts
Re: Which platigage should I use...?
I believe you look at the stock specs for the motor, and choose the plasi based on that. Each one has its own range of clearances that it will show. Im not sure about the blue... But I believe that the red was tighter than the green plasti, and I believe the green plasti was spec'd between .001-.1 I think..... I havent used it in a couple of months, so take that with a grain of salt, and wait for someone who uses it more often jumps in here :D
#3
Re: Which platigage should I use...?
Green, But I wouldn't rely on plastigauge alone as its readings can often differ from actual spec. I would also have it sized with a calibrated bore gauge and micrometer to ensure an accurate reading.
Thread
Thread Starter
Forum
Replies
Last Post
wade
Welding / Fabrication
18
02-24-2008 04:48 PM
Paul Walker
Honda Civic / Del Sol (1992 - 2000)
1
05-01-2002 12:03 PM