how to bleed my slave cylinder?
#1
Thread Starter
Join Date: Feb 2004
Location: manteca, ca, usa
Posts: 61
Likes: 0
Received 0 Likes
on
0 Posts
how to bleed my slave cylinder?
my fluid was out for my clutch so i filled it up but it still sticks once in a while. i was told to bleed the slave cylinder or something like that to get the air pockets out. how do i do this. i have b16 transmission.
#2
The slave is located on the front of the transmission case, to the left of the lower half of the exhaust manifold. To bleed it, depress the clutch a few times (let the hydraulic pressure build up a bit). I believe it is a 10 mm, I may be wrong. Break the nut at the tip of the slave loose in a QUICK manner, the fluid should spray out due to all the pressure built up inside. Do this 3 or 4 times to make sure all the air is out of the system. Air in the hydraulics can make the world of a difference!
Thread
Thread Starter
Forum
Replies
Last Post