CEL code 41 - Primary oxygen sensor heater
#1
Honda-Tech Member
Thread Starter
Join Date: Jun 2004
Location: AL, USA
Posts: 386
Likes: 0
Received 0 Likes
on
0 Posts
CEL code 41 - Primary oxygen sensor heater
What is the primary oxygen sensor heater? I know that there are other codes that are just for the oxygen sensor. but my sensor is plugged up. what does this code mean? thanks!
#3
Honda-Tech Member
Join Date: Oct 2002
Location: chicago burbs, Il, USA
Posts: 5,150
Likes: 0
Received 23 Likes
on
23 Posts
it means that the heater element of the primary O2 has gone bad (or you have a wiring problem)
if you have an ohm meter measure the resistance between the two black wires, it should not be open or more than 1k ohms. If it is more than 1k ohms replace the O2 sensor.
if you have an ohm meter measure the resistance between the two black wires, it should not be open or more than 1k ohms. If it is more than 1k ohms replace the O2 sensor.
#5
Re: (Bruce Lee)
[IMG]<U>Update time</U>:
I finally got my new o2 off the net.
It did take a week, called em , it was back ordered,
but anyway. Got the part, 2 days later went to work on it.
Opening was <U>very simple</U>, but make sure you use lubrication <U></U>a
day b4 and spray it good.
Took me 1/2 and hour to get it done. I took the bad out, tried to clean it, put it back, cel was on. Put ther new o2, ran for few minutes, took for test drive, all was good.
Problem finally solved. <U>Dealer charging $350</U>, haha, forget them. Local repair shop, $100 withought the part.
If you know what ur doing, it's not a big deal.
Either way, car has been running fine, no troubles detected. [/IMG][IMG][/IMG]
Tonight I have to do a regualr tune up...
By the way, the sockect size is the <U>22mm</U>............
I finally got my new o2 off the net.
It did take a week, called em , it was back ordered,
but anyway. Got the part, 2 days later went to work on it.
Opening was <U>very simple</U>, but make sure you use lubrication <U></U>a
day b4 and spray it good.
Took me 1/2 and hour to get it done. I took the bad out, tried to clean it, put it back, cel was on. Put ther new o2, ran for few minutes, took for test drive, all was good.
Problem finally solved. <U>Dealer charging $350</U>, haha, forget them. Local repair shop, $100 withought the part.
If you know what ur doing, it's not a big deal.
Either way, car has been running fine, no troubles detected. [/IMG][IMG][/IMG]
Tonight I have to do a regualr tune up...
By the way, the sockect size is the <U>22mm</U>............
Thread
Thread Starter
Forum
Replies
Last Post
924drb20
Honda Civic / Del Sol (1992 - 2000)
4
12-14-2010 10:36 AM
nwarp
Acura Integra
3
07-17-2004 06:01 PM