Air/Fuel Ratio Gauge Install Question
#1
Thread Starter
Join Date: Jan 2006
Location: Newtown, Connecticut
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
Air/Fuel Ratio Gauge Install Question
Specs: OBD1 P28
93 Del Sol D16z6
Ok, I got the gauge grounded fine, hooked up to swtiched power on the in car fuse box. But I need to find the Oxygen Sensor Signal Wire. The wires that came with the gauge are all only 20 or so inches long so if any of you know if there is a signal wire on the fuse box, that would be preferred. I assume there is one off the ECU. It's no biggie to add more wire. If anyone could tell me exactly where the Oxygen Signal Wire pinout or wire strand is, that would be awsome. Thank You!
93 Del Sol D16z6
Ok, I got the gauge grounded fine, hooked up to swtiched power on the in car fuse box. But I need to find the Oxygen Sensor Signal Wire. The wires that came with the gauge are all only 20 or so inches long so if any of you know if there is a signal wire on the fuse box, that would be preferred. I assume there is one off the ECU. It's no biggie to add more wire. If anyone could tell me exactly where the Oxygen Signal Wire pinout or wire strand is, that would be awsome. Thank You!
#2
Senior Member
Take out the gauge it will not work with our stock narrowband sensor.
You need to install the right gauge/wideband combo to get it to work correctly.
AEM has a wideband/gauge setup
Plx has one as well
i think NGK might have one coming out as well
You need to install the right gauge/wideband combo to get it to work correctly.
AEM has a wideband/gauge setup
Plx has one as well
i think NGK might have one coming out as well
Thread
Thread Starter
Forum
Replies
Last Post
ma_rio44
Honda Civic / Del Sol (1992 - 2000)
8
07-03-2007 08:27 AM