nghtshd88

I just put in my new trans and besides a bad leak at the passenger side axle shaft the trans is throwing the code P0758 which seems to be a solenoid.

It also set off D4 to flashing. Car drives fine mostly except it wont catch when taking off-almost as if I had a clutch and it was burnt, pretty much have to rev to 4k to move.

Once going 2nd to 3rd gear is hard but it moves fine after that.

Can anyone shed any light on the code?

v4lu3s

one of your shift solenoids is either bad or disconnected. i usually start with taking them off and cleaning them out and see if that works to clear the problems up. also make sure they are plugged in while doing all this.

nghtshd88

You mean actually take the solenoid out and clean it right? Not the connector. What are you cleaning them off with. Also when testing for continuity what should they read?

Dy2*str33t-king

U can use brake cleaner because it dries very fast and is very effective in cleaning most dirt and grime.

nghtshd88

Thanks! I have a 6-12 volt tester for the wires.. Or can it only be read in OHM's?