De-pin an obd1 to obd2 jumper harness...
#1
Honda-Tech Member
Thread Starter
iTrader: (1)
Join Date: May 2005
Location: The Bottom of the Map, Miami
Posts: 1,536
Likes: 0
Received 0 Likes
on
0 Posts
De-pin an obd1 to obd2 jumper harness...
Is it possible to de-pin the wires on the jumper side (not the ecu side connectors). I was looking and made an attempt but they are pinned a different style. The connector block isnt like OEM connectors where you can push down a tab and slide out the wire. It looks as if its a fixed opening where the terminal slides and "snaps in". Just wondering if it is possible, TIA.
#2
Honda-Tech Member
Re: De-pin an obd1 to obd2 jumper harness...
So you want to remove a pin on the ECU block side.....not the side that plugs into the ECU, but the female side that receives the underdash ecu plugs?
If so, those pins pull outward....like pull from the female side. So if the wires are still soldered in on the otherside from the ecu plugs....not going to happen.
If so, those pins pull outward....like pull from the female side. So if the wires are still soldered in on the otherside from the ecu plugs....not going to happen.
Thread
Thread Starter
Forum
Replies
Last Post
efhondaracer27
Honda Civic / Del Sol (1992 - 2000)
7
05-31-2010 01:56 PM
216.226.142.95:27016
Tech / Misc
1
01-08-2003 11:45 AM