MFactory shaft brace "CUFF"
#1
Honda-Tech Member
Thread Starter
Join Date: May 2007
Location: las vegas, nevda, us
Posts: 171
Likes: 0
Received 0 Likes
on
0 Posts
MFactory shaft brace "CUFF"
So I just got my MFactory shaft brace "CUFF" and was looking to see if there was any install right ups on here and couldn't find any. I know the basics of how to install it just wanted to see if there was any helpful tips out there. Like how do I know how many of the spacers that come with it I should use or should I use assembly lube ect.
#2
Honda-Tech Member
Join Date: Jan 2009
Location: KS
Posts: 3,906
Likes: 0
Received 0 Likes
on
0 Posts
Re: MFactory shaft brace "CUFF"
this is a liberty install but should be close to the same
https://honda-tech.com/forums/drag-racing-36/tranny-rebuild-darnell-p-liberty-cuff-h-t-pix%2A-2847380/
https://honda-tech.com/forums/drag-racing-36/tranny-rebuild-darnell-p-liberty-cuff-h-t-pix%2A-2847380/
#3
Honda-Tech Member
Thread Starter
Join Date: May 2007
Location: las vegas, nevda, us
Posts: 171
Likes: 0
Received 0 Likes
on
0 Posts
Re: MFactory shaft brace "CUFF"
Yes I seen this it has some good pics but that's about it. More or less just want to know if there are any measurements I need to take before I pull the 5th gear off.
#4
Honda-Tech Member
Join Date: Jan 2009
Location: KS
Posts: 3,906
Likes: 0
Received 0 Likes
on
0 Posts
Re: MFactory shaft brace "CUFF"
all i did was pull 5th lay 3 spacers down, and put the stake nut back on. 3 was to many because reverse didnt wanna stay in gear (kept popping out). pulled 1 spacer off and walla.
pretty much do it till it works for you
pretty much do it till it works for you
#5
Honda-Tech Member
Thread Starter
Join Date: May 2007
Location: las vegas, nevda, us
Posts: 171
Likes: 0
Received 0 Likes
on
0 Posts
Re: MFactory shaft brace "CUFF"
Nice that helps. Would be mad that I had to drop the tranny because it wouldn't stay in reverse. Anyone else have any inputs?
#6
Honda-Tech Member
Thread Starter
Join Date: May 2007
Location: las vegas, nevda, us
Posts: 171
Likes: 0
Received 0 Likes
on
0 Posts
Re: MFactory shaft brace "CUFF"
Ok so I got mine in yesterday. It is way simpler then I thought it was going to be.
(THE LAST PIC IS EVERYTHING YOU TAKE OUT)
(THE LAST PIC IS EVERYTHING YOU TAKE OUT)
Thread
Thread Starter
Forum
Replies
Last Post
vacantskies88
Transmission & Drivetrain
2
09-04-2008 02:04 PM