First time out in 1/4 Mile
#1
Honda-Tech Member
Thread Starter
First time out in 1/4 Mile
After a LONG time of not running 1/4 mile track I was fortunate enough to make it out to Bakersfield to the West Coast Nationals and my car ran very consistent times at low boost.
Best E.T. was 10.46 @ 137.05 mph - Hoping to make it out to Vegas for IFO and see if we can bring the times down a notch.
Best E.T. was 10.46 @ 137.05 mph - Hoping to make it out to Vegas for IFO and see if we can bring the times down a notch.
#6
Honda-Tech Member
Thread Starter
Re: First time out in 1/4 Mile
No straight axle...
It is a simple set up.
B18C5 - 84mm sleeved
9:5.1 Arias Pistons
Crower I Beam Rods
Alaniz Head
Supertech Valvetrain
Type R Cams
Garrett GT35R 24lbs
GSR Stock Trans with LSD
Competition Twin Disk Clutch
3.9 Driveshaft Axles
M&H 25 X 8.7 tires
S300 ECU
1200 RC Injectors
Built buy Ericks Racing
It is a simple set up.
B18C5 - 84mm sleeved
9:5.1 Arias Pistons
Crower I Beam Rods
Alaniz Head
Supertech Valvetrain
Type R Cams
Garrett GT35R 24lbs
GSR Stock Trans with LSD
Competition Twin Disk Clutch
3.9 Driveshaft Axles
M&H 25 X 8.7 tires
S300 ECU
1200 RC Injectors
Built buy Ericks Racing
Trending Topics
#8
Honda-Tech Member
Thread Starter
Re: First time out in 1/4 Mile
9.5.1 Compression and I am using a Type R head which is the same casing as a B16A head - But I didn't use it for any intention other than what I had in my garage to use.
Thread
Thread Starter
Forum
Replies
Last Post