Clifford Matrix 3.3x How to Adjust Alarm Noise
#1
Honda-Tech Member
Thread Starter
Join Date: Oct 2009
Location: Southern Cali
Posts: 318
Likes: 0
Received 0 Likes
on
0 Posts
Clifford Matrix 3.3x How to Adjust Alarm Noise
Hey guys I have a clifford Matrix 3.3X and I was wondering how to adjust noise on alarm. My sirens are really low and there not heard a t all from a distance. I want to raise volume for siren and when I lock and unlock you could barely hear the "Chirps" any ideas or tips?
#5
Honda-Tech Member
Join Date: Oct 2002
Location: State College, PA, 16865
Posts: 3,028
Likes: 0
Received 0 Likes
on
0 Posts
Re: Clifford Matrix 3.3x How to Adjust Alarm Noise
Not sure about the Matrix.. but I know some of the older (I haven't done a newer DEI alarm in a while so not sure about the new ones) had two black loops on the siren.. one you'd cut so it'd only do one siren tone (instead of the various sounds), and one you could cut to "mute" the siren IIRC... or it was cut to make louder, I forget. It's been too long.
#6
Re: Clifford Matrix 3.3x How to Adjust Alarm Noise
see attached file for the loop to cut. keep in mind this only increases your arm/disarm chirp. if you're full trigger volume is low, make sure your ground is clean and voltage drop free, and that the siren opening is not obstructed.
hope this helps.
hope this helps.
Thread
Thread Starter
Forum
Replies
Last Post
teejlc
Audio / Security / Video
19
11-06-2007 01:44 PM