Skunk 2 throttle body install help
#1
Honda-Tech Member
Thread Starter
Join Date: Nov 2012
Posts: 133
Likes: 0
Received 0 Likes
on
0 Posts
Skunk 2 throttle body install help
Just installed 74mm skunk 2 throttle body and there's some left over hoses I thinking there vacum hoses do they just get block of or should they be connect somewhere else
Thanks
Thanks
#4
Re: Skunk 2 throttle body install help
You don't need the hose. I don't know why its still included.
So long as you are running an aftermarket intake manifold with an oversized inlet, used the gasket it came with, calibrated your TPS and have the coolant line that used to run to the throttle body run back to the IACV on the back of the manifold directly you are good to go.
So long as you are running an aftermarket intake manifold with an oversized inlet, used the gasket it came with, calibrated your TPS and have the coolant line that used to run to the throttle body run back to the IACV on the back of the manifold directly you are good to go.
#5
Honda-Tech Member
Thread Starter
Join Date: Nov 2012
Posts: 133
Likes: 0
Received 0 Likes
on
0 Posts
Re: Skunk 2 throttle body install help
Sorry it's 1997 b18c and the coolant hoses on the back of the intake goes back to the iacv and those vacum hoses just blocked of?? Thanks
Thread
Thread Starter
Forum
Replies
Last Post
waynesumner
All Motor / Naturally Aspirated
27
02-18-2017 06:09 PM
chadmasterc
Honda CRX / EF Civic (1988 - 1991)
4
03-01-2006 07:06 PM