HOMEMADEPOWER

I WANT TO KNOW IF I CAN PUT A LS DIZZY ON A GSR HEAD?OR WILL I HAVE TO PUT A GSR DIZZY ON THE GSR HEAD? I KNOW THAT THE LS DIZZY IS A OBO1 BUT IDK IF THE GSR HEAD IS OBO1 OR OBO2.ANY INFO WILL BE HELPFUL.

m_shake

ALL GSR HEADS ARE THE SAME.... turn off the goddamn caplocks!
Not sure if it will bolt up to all three mounting locations and you might have to cut off one of the mounting tabs off the ls distributor(vtec solenoid might be in da way)

GSR CRX

ls distributor will work. cut off the leg closest to the vtec solenoid. only one bolt will be able to line up which is the very top bolt but it fits and works. i had it on my b20 vtec but i swapped it out for a vtec one cause i didnt like the fact that only one bolt was hold the life of my car. i used the b20 dizzy by the way but it should be the same as the ls one that you have

89LSED

IT will work, But yes, you must cut off a leg

93egSLEEPER

Get a GSR dizzy. There is a reason Honda put 3 bolts in it.

N/A

X2

Hitting high rpms is gonna blow that ls distributor apart

m_shake

I had a friend that used my old cheap china d16 dizzy on his b16, saw 8200rpm basically all the time cause he drove like an *** all the time and never had an issue....well smog issues but the dizzy never "blew up"

N/A

How many bolts did he have holding it on is the point, he got lucky if anything..

Having one bolt holding on the distributor is recipe for disaster, think about it..

Oh and I didn't me literally explode lol

m_shake

Oh i don't recommend it, its ghetto as ****!! But to say a ls distributor will blow apart at high rpm isn't exactly true.

The only time i would do it is if the correct dizzy for the head took a dump and I needed to drive the car until the replacement arrived.

N/A

Ok so if I was to rephrase what I said and say a LS distributor is more likely to fail on a gsr head than a gsr, would it make you feel better??

Again, I didn't mean the distributor was going to literally blow apart

m_shake

Yea, def. more likely to fail due to the fact it's being held on by 1/3 of the intended mounting points.

N/A

Next time your around a bike flip it upside down and spin the back tire real fast, then try and tilt the bike while is spinning and see how much turbulence it causes.

That's about the same effect when the distributor tilts just slightly from not being bolted

allmotor k24

Bump cuz I do this all the time wit no problem

N/A

Lol that's great.

Ya try and teach people the right way to do things then of course, a hackjob comes in claiming the hacked way is fine cause he's never had an issue

93egSLEEPER

This is why hondas still get the shitty publicity and we are still called ricers.

Mr. EG

Ha I know right. OP get the distributor meant for your head.

N/A

**** it get a 86 accord dizzy and cut all the mounts off and duct tape it on, it'll work so it must be okay!

HOMEMADEPOWER

Ill play it safe and get a gsr dizzy i dont do ghetto work with my projects.Thanks for da info guys.

N/A

We got a good egg here guys

Frazzo203

i have a b16 obd0 on mine it works mint and im almost pos all 3 bolted up