ej1252

im sure this thread been brought up before but i couldnt find it in search.

im trying to see what my head is so i know what set up i have. i like to know if theres anyways to tell the b16 head jdm or usdm head from the itr head jdm or usdm??

it says 00 on the head too.

91h22cb7lx

the intake side will be ported and polished slightly, and if it still has factory springs they will be dual valve springs, itr ctr and b16 heads are made from the same casting

Top Ramen

Right; if its a complete head, the easiest way to check is to just look at the valve springs. ITR will have an inner set.

ej1252

so your saying that the itr head has dual intake springs or both intake and exhaust?? and the others dont??

ej1252

both intake and exhaust? or just intake?


thanks

Bseriescivic5

both intake and exhaust springs are dual (IE an inner and outer spring) B16 only has dual intake spirngs if I remember correctly. you can also look at the cams to identify assuming they have not been swapped out previously.

ej1252

i see thanks

98civicswapped

he's right b16's only have dual valve springs on the intake side. Took a stock b16 head apart a lil while ago.

Frankacura

Get it double springs. light weight valves ans type R cams and there is no differance betwene the 2 head exept for the R spec one that is lightly ported at the bothom of the valves seat by honda...

Hybrid96EK

You can also look for the yellow or green paint on the dist leg side of the head on the top surface. All R heads have the paint unless someone has "cleaned" the paint off with a harsh cleaner.

dont_loaf

Well I had a couple of B16 heads and they had Pr3 stamped on the exhaust side and a friend of mine had a type R motor and his head was stamped P73

Hybrid96EK

Your friend is completely wrong. His HEAD is stamped PR-3. His INTAKE manifold was most likely where he saw the P73 stamp. The R heads are all slightly worked (intake side ports only) B16 castings. There were none with "P73" casting numbers.

Bseriescivic5

Correct, As stated earyler in this thread the ITR and B16a heads are identical castings. The valve springs would be the first place to look, then cams, then paint. It will be very hard to tell the porting, b/c you just dont know if someone has already ported a stockb16a head.

Frankacura

For the cams if you can show a pic with the end of the cams then the Grooves will tell you GSR b17a/ 94B18c / Si-R 1st/2nd or Integra JDM 96/USDM type R 2001/ CTR

Frankacura

Wit used parts always keep a eye bigger open. cause LOT of peaple will take from a blown Si-R the Intake inserts springs and put them on Si-R exhaust and THINK that is as type R springs... MISTAKE
Almost every things from a type R is bether exept retainers that is all same LOL

ej1252

just ripped open my motor, found out that it has itr cams by looking at the end of it.

still cant tell if its a b16 head or itr cause i cant see the valve springs.


it has green on the intake side springs, does that mean anything??

Bseriescivic5

If you pulled the valve cover, you should easilly be able to see the springs.

ej1252

still couldnt see it haha, im about to just take one retainer and go from there

Frankacura

Green on Intake IS defenetivly Si-R springs... Kind of tane on EX.

ej1252

yeaaa